Volkswagen Golf / Golf GTI / Jetta. Manual — part 365
01-142
A B
C D
E
Perform directed
entry of electrical
tests
Service
hydraulic/mechanical
parts of brake system
(
Repair Manual
Brake System)
1.
Perform all test
steps of electrical
checks
from
Page 01-288
Identification not OK.
2. Service
hydraulic/mechanical
parts of brake
system
(
Repair Manual
Brake System)
Replace control module
- Connect V.A.G 1551 scan tool or tester VAS 5051 and check DTC
memory 02.
- Erase DTC memory (05)
- Perform test drive at more than 20 km/h (13 mph) and allow the ABS
regulate braking.
- Check DTC memory after test drive. If "No DTC recognized" appears on
display of V.A.G 1551 scan tool or tester VAS 5051 after repair DTCs and
perform test drive, the On Board Diagnostic (OBD) is completed.
ABS Mark 60 On Board Diagnostic (OBD), vehicles from my 10.00
01-143
Electrical/electronic
components and
installing locations
Repair Manual, Brake
System, Repair Group 45;
Hydraulic unit, brake
booster/master cylinder
Assembly overview; Removing
and installing control module
and hydraulic control part
1 - ABS hydraulic unit
N55-
Located on left of
engine compartment.
The ABS hydraulic
pump -V64-
inlet/outlet valves in the
hydraulic unit are
checked by On Board
Diagnostic (OBD)
The ABS hydraulic
pump -V64-
block must not be
separated from one
another
Removing and
installing
When changing the
hydraulic unit, always
seal the old part with
the plugs from the
repair set Part No. 1H0
698 311 A
Electrical/electronic components and installing locations
01-144
Vehicles with
ABS/ESP only
2 - ABS
Control
Module
(w/EDL) -
J104-
Location: on
hydraulic
unit on left of
engine
compartment
Checked
by On
Board
Diagnostic
(OBD)
Checking
the multi-
pin
connector
to control
module
Page
01-292
Do not
disconnect
connector
before
successfully
completing
On Board
Diagnostic
(OBD).
Switch
ignition off
before
separating
connection.
When the
ABS Control
Module
(w/EDL) -
J104- is
replaced, a
Electrical/electronic components and installing locations
zero
compensation
must be
performed
Initiate
basic
setting
Page
01-264
,
perform
display
group
numbers
060,
063, 066
and 069
Electrical/electronic components and installing locations
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст