Volkswagen Golf / Golf GTI / Jetta. Manual — part 715
All lights in door trim will flash for approx. 15 seconds after
switching on ignition.
Overcoming resistance with excess force
limitation (Pinch protection)
Requirement: Automatic opening and closing is OK.
Ignition switched on.
- Close door window with window regulator switch
(automatic opening).
If a window is hindered by resistance or by an obstacle
during closing sequence, window opens again immediately
(PP has been activated).
- After window has opened, lift/press and hold switch of
corresponding window again within 5 seconds.
If window still cannot be closed by resistance or by an
obstacle, window immediately remains standing (PP has
been activated).
- After window remains standing, switch must be operated
again within 5 seconds in order to close window.
Window now closes over obstruction without force
limitation.
Ignition switched off.
If a window is hindered by resistance or by an obstacle
during closing sequence, window opens again immediately
(PP) has been activated).
Operating window regulator switch from inside has now
been locked.
If ignition is switched on within 1 minute after opening
window and then switch is pressed (close window), window
is closed without automatic run-up.
Window regulator motor or carrier assembly
with window regulator, removing and
installing
Removing
Illustration shows removal and installation of window
regulator motor/carrier assembly with window regulator for
Door windows
13/2/2005
rear doors. Removing and installing for front doors is
performed in same way.
Removing front or rear carrier assembly
64-2, Carrier
assembly, removing and installing
or
64-2, Carrier
assembly, rear door window and quarter window, removing
and installing
.
- Slide a hammer handle between window guide and carrier
assembly so far until hammer handle end presses on gears
of carrier assembly.
- Remove bolts - 1 - and remove window regulator.
Window regulator motor, installing
- By removing window regulator motor, gearing shifts, it is
not centered.
- When installing window regulator motor, gears must be
aligned until window regulator motor is centered again.
Door windows
13/2/2005
- Attach and tighten bolts - 1 - .
Tightening torque: 3.5 Nm
Tightening torque must always be observed since
otherwise damage to plastic sleeve on window regulator
motor can result.
Carrier assembly with window regulator,
installing
For replacement part carrier assemblys, gearing is secured
against slipping and falling by a cable tie - 1 - .
- Slide a hammer handle between window guide and SF so
far until hammer handle end presses on gears of SF.
Door windows
13/2/2005
- Remove cable tie - 1 - .
- By removing window regulator motor, gearing shifts, it is
not centered.
- When installing window regulator motor, gears must be
aligned until window regulator motor is centered again.
- Attach and tighten bolts - 1 - .
Tightening torque: 3.5 Nm
Tightening torque must always be observed since
otherwise damage to plastic sleeve on window regulator
motor can result.
Carrier assembly with window regulator,
assembly overview
Door windows
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст