Volkswagen Golf / Golf GTI / Jetta. Manual — part 825
01-77
Evaluating display group number 003
Display
zone
Designation
Display
contents
Corrective action
1
Voltage supply
correct
too low
too high
Electrical Wiring Diagrams,
Troubleshooting &Component
Locations
Electrical wiring diagrams &
Component locations
- Battery voltage min. 9 Volt
- Check alternator
- Check voltage regulator
- Visual check of wiring
2
Passenger side seat
occupant detection
not installed no malfunction present
Continued on next page
Airbag system, On Board Diagnostic (OBD)
13/2/2005
01-78
Display
zone
Designation
Display
contents
Corrective action
3
Left Front
Seatbelt
Microswitch -
F140-
not
installed
belt: yes
belt: no
too high
too low
to Ground
(GND)
to B+
not
defined
If the switch is not installed or if "belt
yes" is displayed with belt tongue
inserted or "belt no" with the belt tongue
not inserted, no malfunction is present
- Visual check of wiring
- Check harness connectors of the
respective electrical circuit for proper and
secure seating and observe the display at
the same time If the display content
changes to "correct", erase DTC memory
4
Right Front
Seatbelt
Microswitch -
F141-
not
installed
belt: yes
belt: no
too high
too low
to Ground
(GND)
to B+
not
defined
- Replace faulty wires or harness
connectors
- Replace driver- or passenger-side belt
buckle switch
Airbag system, On Board Diagnostic (OBD)
13/2/2005
01-79
Display group 005
Display group 005
Read Measuring Value
Block 5
Indicated on display
xxx
xxx
xxx
xxx
1
2
3
4
Display zones
Specification Evaluation
Rear near side, side
airbag igniter -N202-
not installed
Rear off side, side airbag
igniter -N201-
not installed
Front passenger's, side airbag igniter -
N200-
correct
Page 01-
80
Driver's, side airbag igniter -N199-
correct
Airbag system, On Board Diagnostic (OBD)
13/2/2005
01-80
Evaluating display group number 005
Display
zone
Designation
Display
contents
Corrective action
1
Driver's side, side
airbag igniter -N199-
correct
too high
too low
Trig.
Ground
Trig.
positive
- Visual check of wiring
- Watch display and check connectors
of appropriate current circuit for correct
engagement and tight fit. If display
changes to "correct", erase DTC
memory.
- Replace faulty wiring or connections
2
Front passenger's
side, side airbag
igniter -N200-
correct
too high
too low
Trig.
Ground
Trig.
positive
- Replace driver's or front passenger's
side, side airbag
3
Igniter for side
airbag rear, drivers
side -N201-
not
installed
no malfunction present
4
Igniter for side
airbag rear,
passenger side -
N202-
not
installed
Airbag system, On Board Diagnostic (OBD)
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст