Volkswagen Golf / Golf GTI / Jetta. Manual — part 814
01-33
End output
- Press buttons -0- and -6- to end
the output.
Rapid data transfer
Q
06 End output
Indicated on display:
- Confirm entry with the -Q- button.
Rapid data transfer
HELP
Enter address word XX
Indicated on display:
- Switch off ignition.
- Disconnect connector to V.A.G
1551 scan tool.
Airbag system, On Board Diagnostic (OBD)
13/2/2005
01-34
Diagnostic Trouble Code (DTC) table
Note:
The following table lists all the malfunctions, with the corresponding 5-digit code
numbers, that can be recognized by the Airbag Control Module -J234- and printed
out by the V.A.G 1551.
The most current coding for airbags can only be found using the VAS 5051. To get
the control module coding list through Guided Fault Finding press the "Go to" button,
and select "Function/Component selection". Follow the prompts through to Functions
- Code Airbag Control Module..
DTC's appear only on print-out.
Some of the mentioned DTC texts are only displayed on the VAS 5051. On the
V.A.G 1551, only the DTC will be printed in this case.
The possible malfunctions are dependant on the respective vehicle equipment.
Before replacing a component shown as malfunctioning, check wiring and
connections to the component as well as Ground connections according to wiring
diagram.
Check all relay plate connections are seated securely.
After completing repairs, the DTC memory must always be re-checked and erased
using the V.A.G 1551 scan tool.
In addition, the malfunction type may also appear in the DTC table.
V.A.G 1551
display
Possible cause
Corrective action
00000
No DTC
recognized
If "No DTC recognized" appears after performing repairs, the On
Board Diagnostic (OBD) is ended.
Airbag system, On Board Diagnostic (OBD)
13/2/2005
01-35
V.A.G 1551
display
Possible cause
Corrective action
00532
Supply
voltage
Signal too
large
Alternator malfunctioning
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations
- Test alternator
Signal too
small
Wiring or connections to Airbag
Control Module -J234-
- Test wiring and connections to
control module using wiring diagram
Battery discharged or
malfunctioning
- Charge or replace battery
Airbag system, On Board Diagnostic (OBD)
13/2/2005
01-36
V.A.G 1551 display
Possible cause
Corrective action
00588
Airbag igniter -
driver's side -N95-
Resistance too high
Resistance too low
Short to B+
Short to Ground
Faulty wiring or connections
- Replace faulty wiring or
connections
Driver's airbag -N95-
malfunctioning
- Replace driver's airbag -
N95-
Coil connector with slip ring -
F138- malfunctioning
- Replace coil connector
with slip ring
- Read Measuring Value
Block
Page 01-69
Airbag system, On Board Diagnostic (OBD)
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст