Volkswagen Golf / Golf GTI / Jetta. Manual — part 813
01-29
If the control module code number
entered is not accepted, then the
"FAULT" and the "code xxxxx not
accepted" will be displayed, e.g.
00200:
FAULT
Coding 00200 not accepted
Indicated on display:
In this case the control module has
not been programmed with the
relevant data for the vehicle. Coding
is then not possible. The Airbag
Malfunction Indicator Lamp (MIL) -
K75- will not extinguish and lights up
continuously. A check must then be
completed to see if the correct
control module for the vehicle has
been installed (compare Part No.
and letter index), or whether an
incorrect code number has been
entered.
End output:
- Press
button.
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -6- to end
the output.
- Confirm entry with the -Q- button.
Rapid data transfer
Q
06 End output
Indicated on display:
Airbag Malfunction Indicator Lamp
(MIL) -K75- must go out after
approx. 4 seconds.
Airbag system, On Board Diagnostic (OBD)
13/2/2005
01-30
Check DTC Memory
- Connecting scan tool
Page 01-3
, initiating On
Board Diagnostic (OBD)
Page 01-7
.
- Switch on printer with Print button (warning lamp
in button lights up).
- Press buttons -0- and -2- (the function "Check
DTC memory" is entered with 02).
Rapid data transfer
Q
02 - Check DTC memory
Indicated on display:
- Press "Print" button.
- Confirm entry with the -Q- button.
X DTCs recognized!
The number of stored malfunctions appears in the
display.
The stored malfunctions are displayed and printed
out one after the other.
- Enter DTC table at malfunction printed out and
repair.
No DTC recognized!
If "No DTC recognized" is displayed, the program
will return to the initial position after pressing the
button.
Airbag system, On Board Diagnostic (OBD)
13/2/2005
01-31
Rapid data transfer
HELP
Select function XX
Indicated on display:
If something else is displayed:
Scan tool operating instructions
Note:
If a DTC is recognized:
- End output (function 06)
Page
01-33
.
- Switch off ignition and separate
diagnostic connections.
1 . Repair malfunction
2. Erase DTC memory (function
05).
3. Check DTC memory again
(function 02).
Airbag system, On Board Diagnostic (OBD)
13/2/2005
01-32
Erase DTC memory
- Connecting scan tool
Page 01-3
, initiating On
Board Diagnostic (OBD)
Page 01-7
.
- Switch on printer with Print button (warning lamp
in button lights up).
Prerequisites:
DTCs are repaired
DTC memory checked again
- Press buttons -0- and -5- (the function "Erase
DTC memory" is entered with 05).
Rapid data transfer
Q
05 Erase DTC memory
Indicated on display:
- Confirm entry with the -Q- button.
Rapid data transfer
DTC memory is erased!
Indicated on display:
- Press
button.
Rapid data transfer
HELP
Select function XX
Indicated on display:
Note:
WARNING!
DTC memory was checked not
If this appears in the display, the test sequence
is faulty.
Adhere strictly to test sequence; first of all
check DTC memory, then erase memory.
Airbag system, On Board Diagnostic (OBD)
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст