Volkswagen Golf / Golf GTI / Jetta. Manual — part 353
01-74
Output Diagnostic Test Mode (DTM)
Note:
All functions which could previously be
performed with V.A.G 1551 can also be
performed with the tester VAS 5051.
The pump motor and the correct functioning of
the hydraulic circuits (allocation of brake lines to
wheel cylinders and function of valves) can be
checked via the output DTM for interchange or
leaks.
The vehicle must be raised until all wheels are
free to turn. (2nd mechanic required to rotate
wheels)
The -C- key can be used to exit the test
sequence at any time.
After depressing the brake pedal several times
the vacuum in the brake booster will be
exhausted. Therefore more pressure must be
applied to the brake pedal in order to attain the
same fluid pressure in brake system, as that
attained with vacuum.
When vacuum in brake booster is exhausted
wheels may not lock; start engine and build-up
vacuum in brake booster.
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-75
Example:
Indicated on V.A.G 1551 display during
output Diagnostic Test Mode (DTM):
(e.g. front left wheel, FL)
Output Diagnostic Test Mode -
IFL: VBAT OFL: 0V Wheel FL locked
IFL = Inlet valve Front Left
VBAT = Voltage Battery; Voltage at valve
OFL = Outlet valve Front Left
0V = 0 Volt; No voltage at valve
Locked/free = Wheel condition; must be
checked by 2nd mechanic if required
Output Diagnostic Test Mode -
EDL valves/Hyd-P: VBAT Wheel FL/FR
locked
Hydr-P = Hydraulic pump
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-76
- Connect V.A.G 1551 Scan Tool.
- Switch ignition on.
- Press key -1- for "Rapid data transfer" operating
mode.
- Select brake electronics (address word 03);
Page 01-23
Rapid data transfer
Q
03 - Brake electronics
Indicated on display
Note:
During the next work steps the ABS warning light -
K47- flashes.
- Confirm entry with key Q.
- Read off control module version in V.A.G 1551
display.
- Press
key.
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-77
Rapid data transfer
HELP
Select function XX
Indicated on display
- Press keys 0 and 3
Rapid data transfer
Q
03 - Output Diagnostic Test Mode
Indicated on display
- Confirm entry with key Q.
ABS hydraulic pump -V64- must
run.
Output Diagnostic Test Mode
-
ABS hydraulic pump - V64
Indicated on display
- Press
key.
Output Diagnostic Test Mode
-
Operate brakes
Indicated on display
- Operate brake pedal.
- Press
key.
Output Diagnostic Test Mode
-
IFL: 0V OFL: 0V
Wheel FL locked
Indicated on display
Note:
If the wheel does not lock, there is a
possibility that there is a malfunction
in the mechanical/hydraulic part of
the brake system.
- Indicate to 2nd mechanic which
wheel requires turning by hand.
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст