Volkswagen Golf / Golf GTI / Jetta. Manual — part 352
01-70
Checking brake light switch for
ABS and ABS/EDL function
Display group number 003
- Press keys 0, 0 and 3
- Confirm entry with key Q.
Read measured value block
3
1
2
3
4
There are always 4 display zones -
arrows- in the measured value block.
Decoding the individual values in
display zones 1 to 4 can be read
from the following tables.
Read measured value block
3
0
Indicated on display
Press C key for the next display
group number entry.
If the
key is pressed, keys 0 and
8 for work sequence "Read
measured value block" must be
pressed again afterwards to regain
entry.
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-71
Read measured value block
3
Display group number: 003
0
Indicated on display
Vacant
Vacant
Vacant
Brake light switch:
If despite pressed foot brake a -0-, or not pressed foot brake a -1- is displayed
on the V.A.G 1551 display; perform test step No. 4 of Electrical check,
Page
01-102
.
There is also a possibility that the brake light switch has not been correctly
adjusted. Adjusting brake light switch,
Page 01-131
.
0
Brake pedal not depressed
1
Brake pedal depressed
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-72
Checking data bus wiring
Display group number 125
- Press keys 1, 2 and 5
- Confirm entry with key Q.
Read measured value block 125
1
2
3
4
There are always 4 display zones -
arrows- in the measured value block.
Decoding the individual values in
display zones 1 to 4 can be read
from the following tables.
Read measured value block
125
Engine 1 4WD 1 Gear. 1
Indicated on display: (vehicle
stationary)
Press C key for the next display
group number entry.
If the
key is pressed, keys 0 and
8 for work sequence "Read
measured value block" must be
pressed again afterwards to regain
entry.
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
01-73
Read measured value block 125
Display group number: 125
Engine
1
AWD
1
Gear.
1
Indicated on display (example)
Vacant
Data bus connection for transmission
1)
1
Data bus connection is available.
0
Data bus connection is not available.
3)
Data bus for all-wheel drive
2)
1
Data bus connection is available.
0
Data bus connection is available.
Data bus for engine
1
Data bus connection is available.
0
Data bus connection is not available.
1)
Vehicles with automatic transmission only.
Incorrect transmission control module or incorrect transmission control module
coding.
Transmission control module faulty.
Repair Group 01 for relevant transmission code.
2)
All-wheel drive vehicles with Haldex coupling only.
3)
Data bus connection is interrupted or data bus wires are interchanged.
Electrical Wiring Diagrams, Troubleshooting & Component Locations binder.
ABS ITT Mk 20 IE On Board Diagnostic (OBD) program
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст