Volkswagen Golf / Golf GTI / Jetta. Manual — part 559
- Remove bolt - 1 - and/or - 2 - .
3 - Upper transverse link
4 - Lower transverse link
5 - Trailing arm
- Remove bolt - 1 - and/or - 2 - .
To make easier disassembly/assembly remove bolt - 5 - if
necessary.
3 - Upper transverse link
4 - Lower transverse link
Installing
Installation is carried out in reverse sequence.
Tighten vehicle to lifting platform
Caution!
Trailing arm and transverse links (all-wheel drive vehicles), assembly overview
If the vehicle is not secured, there is a risk that it may
slip off the hoist.
- Remove plugs from trailing arm - 3 - and tighten
tensioning strap .
1 - Support arm of lifting platform
2 - Tensioning strap T10038 ; The vehicle must be fastened
with the tensioning straps on left and right side.
Tightening bearing bracket is only possible, when the
measured value - a - from middle of wheel hub to lower
edge bordering wheel housing is reached.
- Turn wheel hub until one of the holes for the wheel bolts is
at the 12 o'clock position.
- Install wheel hub support T10149 with a wheel bolt.
- Raise wheel bearing housing using engine/transmission
jack until dimension - a - is reached.
Caution!
n
Do not raise or lower the vehicle if the
engine/transmission jack is under the vehicle.
n
Do not leave engine/transmission jack under the
Trailing arm and transverse links (all-wheel drive vehicles), assembly overview
vehicle longer than necessary.
- Tighten bolts from bearing bracket to rear axle with
tightening torque.
Check camber and toe adjustment on alignment
machine after installing.
Fastener/location
Tightening torques:
Transverse link to trailing arm
Use new nuts and bolts!
70 Nm plus an additional
1
/
4
turn 90
Transverse link to subframe
Use new nuts and bolts!
70 Nm plus an additional
1
/
4
turn 90
Drive axle to final drive flange shaft
40 Nm
Trailing arm and transverse links (all-wheel drive vehicles), assembly overview
42 - 6
Subframe with final drive, assembly
overview
1. Multiple point socket head bolt,
60 Nm
2. Bonded rubber bushing for final
drive
¡
Removing and installing
42-
6, Bonded rubber bushings for
final drive, removing and
installing
3. Multiple point socket head bolt,
60 Nm
4. Bonded rubber bushing for
subframe
Subframe with final drive, assembly overview
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст