Volkswagen Golf / Golf GTI / Jetta. Manual — part 668
.
If there is an electrical malfunction via window regulator
motor, this can be removed from carrier assembly.
Removing
- Removing front door trim
.
Repair Manual, Body Interior, Repair Group 70, Door
trim, removing and installing
- Removing and installing lock cylinder housing
57-1,
Lock cylinder housing, removing and installing
.
- Unclip clip - 1 - from door handle.
- Pry off caps - 1 - .
Front door
13/2/2005
- Lower door window until securing bolts of door window
are accessible.
Note:
If work step is not possible due to a malfunction via
electrical window regulator, window regulator motor can be
removed to be able to slide window down.
- Loosen bolts - 2 - and press clamping brackets apart.
- Slide door windows upward and secure (e.g. using
adhesive tape).
- Disconnect all connectors - arrows - .
- Remove bolts - 2 - .
Tightening torque: 20 Nm
Front door
13/2/2005
- Remove bolts - arrows - . Remove upper carrier
assembly from door, lift and lift out from door toward door
hinges.
- Rotate carrier assembly and disconnect connector from
door lock.
- Then, unclip clips for electrical wires from rear side of
carrier assembly.
- Drive out clips - 1 - using a drift.
Front door
13/2/2005
- Unclip cable - 2 - from clip - 1 - .
- Using a screwdriver - 3 - , pry off door lock with assembly
aid from carrier assembly.
Note:
Angle bracket is not part of parts supplied with door lock. It
is secured to door lock with a bolt and a blind rivet.
- Unclip locking rod - 1 - . To do so, turn door lock in
direction of - arrow - .
- Unclip cable - 2 - .
- Turn end of cable 90 and remove from eyelet.
Installing
Front door
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст