Volkswagen Golf / Golf GTI / Jetta. Manual — part 657
1. Locking clamp
2. Handle
¡
Removing
- Unclip lid trim (handle is
secured with a bolt).
- Unclip pull lever
Item -
5 -
, pry out locking clamp
Item - 1 -
and remove
lock cylinder housing from
handle.
- Disconnect connector for
luggage compartment light
and unclip operating rod for
central locking system if
necessary.
- Remove Torx bolts
Rear lid (Golf)
13/2/2005
3. Actuator securing bolt
¡
Loosen and tighten using Socket
wrench T10010
4. Central locking actuator
¡
Removing
5. Pull lever
6. Torx screw
7. Operating rod
¡
Press actuator lever
Item - 11 -
against stop and engage operating
rod free of tension
8. Lock cylinder housing
¡
Removing
9. Lock
¡
Removing
Item - 6 -
and remove
handle from lid.
- Disconnect connector
from actuator.
- Remove actuator using
Socket wrench T10010 and
remove from lid.
- Unclip lid trim (handle is
secured with a bolt).
- Unclip pull lever
Item -
5 -
, pry out locking clamp
Item - 1 -
and remove
lock cylinder housing from
handle.
- Remove lid trim
Rear lid (Golf)
13/2/2005
¡
install - only with striker catch in
detent
10. Oval-head machine screw
¡
20 Nm
11. Actuator lever
.
Repair Manual, Body Interior, Repair
Group 70, Rear lid trim; removing and
installing lower trim for rear lid
- Disconnect connector
from lock.
- Unclip operating rod
Item - 7 -
, remove bolt
Item - 10 -
and remove lock
from lid.
Installing
- Engage locking clamp again.
- Position lock cylinder housing on to grip piece and lock in
handle with an audible click.
- Then proceed in reverse order of removal.
Lock cylinder housing, removing and
installing
Rear lid (Golf)
13/2/2005
1. Handle
2. Guide sleeves
3. Handle recess
4. Seal
5. Retaining clip
6. Pin
7. Circlip
8. Spring
9. Seal
10. Lock cylinder housing
¡
Removing
- Unclip lid trim (handle is
Rear lid (Golf)
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст