Volkswagen Golf / Golf GTI / Jetta. Manual — part 136
01-123
If no electrical or wiring concerns are
found:
- Check wire for open circuit
between test box socket 46 and
terminal 4 on relay plate referring
to Electrical Wiring Diagrams.
Wire resistance: max. 1.5
- Replace Motronic Engine Control
Module (ECM) -J220-
Page 24-
173
.
- Check DTC memory, repair
Diagnostic Trouble Codes (DTCs)
if necessary and then erase DTC
memory
Page 01-23
, DTC
memory, checking and erasing.
- Erase learned values and adapt
Motronic Engine Control Module
(ECM) -J220- again
Page 24-
182
.
- Read readiness code
Page 01-
146
. If the DTC memory has
been erased or the Motronic
Engine Control Module (ECM) -
J220- was disconnected from
battery (B+) positive, the
readiness code must be
generated again
Page 01-149
.
Output Diagnosis Test Mode (DTM)
01-124
4. Activating Intake Manifold
Change-Over Valve -N156-:
- Press
button.
Output Diagnosis Test Mode
Intake Manifold Change-Over Valve -N156-
Indicated on display:
Note:
If there is sufficient vacuum the
Intake Manifold Change-Over Valve
-N156- activates the intake manifold
change-over valve actuator. The
change-over valve is located below
the intake manifold, on right next to
the Secondary Air Injection (AIR)
Solenoid Valve. Checking variable
intake manifold change-over
Page
24-117
.
If the valve does not click:
The Intake Manifold Change-Over
Valve must click until the next
final control element is activated
by pressing
button.
- Disconnect 2-pin connector from
Intake Manifold Change-Over
Valve -N156- (arrow).
Output Diagnosis Test Mode (DTM)
01-125
LED flashes:
- Connect LED test light VAG 1527
to detached connector using
adapter cables from VAG 1594.
LED must flash (bright/darker)
- Press -C- button to abort output
Diagnosis Test Mode (DTM).
Output Diagnosis Test Mode was aborted
Indicated on display:
- Switch off ignition.
- Replace Intake Manifold Change-
Over Valve -N156-
Page 24-
12
, item 2 .
- Check DTC memory, repair
Diagnostic Trouble Codes (DTCs)
if necessary and then erase DTC
memory
Page 01-23
, DTC
memory, checking and erasing.
- Read readiness code
Page 01-
146
. If the DTC memory has
been erased or the Motronic
Engine Control Module (ECM) -
J220- was disconnected from
battery (B+) positive, the
readiness code must be
generated again
Page 01-149
.
Output Diagnosis Test Mode (DTM)
01-126
LED does not flash:
- Press -C- button to abort output Diagnosis Test
Mode (DTM).
Output Diagnosis Test Mode was aborted
Indicated on display:
Repair Manual, Electrical Equipment; Repair
Group 92
- Switch off ignition.
- Remove wiper arms and cowl panel:
- Connect test box VAG 1598/31 to control
module wiring harness. Engine Control Module
(ECM) -J220- remains disconnected.
Output Diagnosis Test Mode (DTM)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст