Volkswagen Golf / Golf GTI / Jetta. Manual — part 134
01-115
- Disconnect 2-pin connector from
Secondary Air Injection (AIR)
Pump Motor (arrow).
- Connect LED test light VAG 1527
to disconnected connector using
adapter cables from VAG 1594.
LED must flash
Output Diagnosis Test Mode (DTM)
01-116
LED flashes:
- Press -C- button to abort output Diagnosis Test
Mode (DTM).
Output Diagnosis Test Mode was aborted
Indicated on display:
Repair Manual, 2.8 Liter VR6 4V Engine
Mechanical, Engine Code(s): BDF; Repair Group
26
If the LED does not flash but the Secondary Air
Injection (AIR) Pump Relay clicks:
- Switch off ignition.
- Replace Secondary Air Injection (AIR) Pump
Motor -V101-:
- Check DTC memory, repair Diagnostic Trouble
Codes (DTCs) if necessary and then erase DTC
memory
Page 01-23
, DTC memory, checking
and erasing.
- Read readiness code
Page 01-146
. If the
DTC memory has been erased or the Motronic
Engine Control Module (ECM) -J220- was
disconnected from battery (B+) positive, the
readiness code must be generated again
Page 01-149
.
- Press -C- button to abort Output Diagnosis Test
Mode (DTM).
Output Diagnosis Test Mode was aborted
Indicated on display:
- Switch off ignition.
Output Diagnosis Test Mode (DTM)
01-117
If no electrical or wiring concerns are
found:
- Check wire for open circuit
between Secondary Air Injection
(AIR) pump motor -V101- terminal
1 and body Ground (GND).
Wire resistance: max. 1.5
Note:
- Pull Secondary Air Injection (AIR)
Pump Relay -1- out of relay
carrier in protective housing for
control modules.
If tools are necessary to pull
relays or control modules out of
the relay plate, first disconnect
battery Ground (GND) strap.
Before disconnecting battery
Ground (GND) strap obtain code
for radios with anti-theft coding.
Output Diagnosis Test Mode (DTM)
01-118
If no electrical or wiring concerns are
found:
- Check wiring for open circuit
between connector terminal 2 on
Secondary Air Injection (AIR)
Pump Motor and terminal 2 on
relay plate.
- Wire resistance: max. 1.5
If no electrical or wiring concerns are
found:
- Check wire for open circuit
between terminal 1 of relay plate
and fuel pump (FP) relay -J17-
referring to Electrical Wiring
Diagrams.
Wire resistance: max. 1.5
- Replace Secondary Air Injection
(AIR) pump relay -J299-.
- Check DTC memory, repair
Diagnostic Trouble Codes (DTCs)
if necessary and then erase DTC
memory
Page 01-23
, DTC
memory, checking and erasing.
Output Diagnosis Test Mode (DTM)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст