Volkswagen Golf / Golf GTI / Jetta. Manual — part 427
45-88
Speed sensor on rear axle(front
wheel drive), removing and
installing
Removing
- Raise vehicle.
Installing
- Disconnect speed sensor and
speed sensor wiring connector -1-
.
- Remove bolt -2- from stub axle.
- Pull ABS speed sensor out of
stub axle.
- Before inserting speed sensor,
clean mounting hole inner surface
and coat speed sensor with solid
lubricant paste G 000 650.
- Insert speed sensor into hole in
stub axle and tighten bolt to 8 Nm
(71 in. lb)
- Connect speed sensor to speed
sensor wiring.
ABS system components for front and rear axles, removing and installing
45-89
Rear speed sensor wiring (front
wheel drive), removing and
installing
Special tools and equipment
Removing:
Repair Manual, Body Interior,
Repair Group 70; Pillar and side
panel trim; Removing wheel housing
trim.
VAS 1978 Wiring harness repair
kit
- Obtain radio code on vehicles
with coded radio.
- Disconnect battery.
- Disconnect speed sensor
wiring/speed sensor connection.
- Remove rear side panel trim.
- Disconnect speed sensor wiring
(arrow) with wire strippers from
VAS 1978 and remove faulty
wiring.
ABS system components for front and rear axles, removing and installing
45-90
- Strip 15 mm (5/8 in.) of insulation
from end of wire with wire stripper
and fold half of stripped wire
back.
- Guide in new speed sensor
wiring.
- Connect speed sensor to speed
sensor wiring.
Make sure the wiring is not twisted
when installing the speed sensor
wiring in the wheel housing.
- Clip in speed sensor wiring
(arrow).
- Cut 2-pin connector off new
speed sensor wiring with wire
stripper pliers.
- Strip 15 mm (5/8 in.) of insulation
from end of wire with wire
strippers and bend back half.
- Connect speed sensor wiring with
aid of suitable crimp connector
from wiring harness repair set
VAS 1978.
ABS system components for front and rear axles, removing and installing
45-91
ABS system
components
for rear axle
(all-wheel
drive),
removing
and
installing
1 - ABS
speed
sensor
Checked
by On
Board
Diagnostic
(OBD)
Before
inserting
sensor,
clean
fitting
hole
inner
surface
and
coat
with
lubricant
paste G
000 650
All-
wheel
drive
Page
45-93
2 - Hex
socket
head
bolt, 8
Nm (71
in. lb)
3 - Trailing
arm
ABS system components for front and rear axles, removing and installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст