Volkswagen Golf / Golf GTI / Jetta. Manual — part 696
3. Bolt
¡
Qty. 6
¡
1.5 Nm
4. Speed nut
¡
Qty. 6
5. Clip
¡
Qty. 12
6. Center ventilation grid
¡
Removal of ventilation grid only
possible with bumper cover
removed
Item - 1 -
¡
Removing
¡
Installing:
- Remove bumper cover
Item - 1 -
.
- Remove clamps
Item -
5 -
.
- Remove center ventilation
grid.
Installation is performed in the
reverse order of removal. Note
the following:
- Damaged clamps
Item
- 5 -
must be replaced.
Bumper carrier (Golf R32), assembly
overview
63-1, Bumper carrier, assembly overview
Front bumper
13/2/2005
63 - 2
Rear bumper
Rear bumper cover, assembly overview
Note :
Slight changes may have to be made to
removal and installation procedures,
depending upon equipment installed in
vehicle.
1. Rear bumper cover
¡
Material - PP/EPDM
¡
Removing
63-2, Rear bumper
cover, removing and installing
2. Guide piece
Rear bumper
13/2/2005
¡
To remove and install, pull out/slide
in bumper cover parallel out of
guide pieces (left and right sides)
3. Bolt
¡
Qty. 8 (for common models
Golf/Jetta)
¡
Qty. 10 (for Jetta GLI Sport)
¡
1.5 Nm
4. Mounting strip
5. Bolt
¡
Qty. 4
¡
6.6 Nm
6. Impact strip
¡
For common models Golf/Jetta:
clipped in cover
¡
For Jetta GLI Sport: delivered as
by-pack
¡
It is not necessary to remove when
removing cover
63-2, Rear
bumper cover, removing and
installing
.
7. Bolt
¡
6.6 Nm
¡
Only on Jetta models
Rear bumper cover, removing and installing
Rear bumper
13/2/2005
Removing
- Loosen bumper cover - 1 - in area of
wheelhousing (bolts - 3 - ).
- Removing tail light assembly
.
Repair Manual, Electrical Equipment,
Repair Group 94, Tail light assembly
- Disconnect connector (below left tail
light assembly) for license plate light (Golf
only).
- Remove bolts - 5 - . For Jetta, remove
additional bolt - 7 - .
- Remove bumper cover - 1 - from guide
pieces - 2 - (left and right sides) and
Rear bumper
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст