Volkswagen Golf / Golf GTI / Jetta. Manual — part 775
- Fold seat cushion and backrest forward.
- Remove press button - 2 - from stud - 5 - .
- Remove trim - 1 - from body flange - 4 - with clips - 3 - .
Installing
- Installation is reverse of removal.
Wheel housing trim, removing and installing
(Jetta)
Removing
- Remove rear shelf
70-3, Rear shelf, removing and
installing
.
- Fold seat cushion and backrest forward.
- Remove press button - 1 - .
- Remove plugs - 2 - using Disassembly
pliers 3392 .
Pillar and side trim
13/2/2005
- Loosen trim - 3 - in area of clips - 4 - and
remove.
Installing
- Installation is reverse of removal.
Wheel housing trim, removing and installing
(Golf wagon/Jetta wagon)
Note:
n
Removal and installation is described for right side of
vehicle. same instructions apply for removal and
installation for left-hand side.
n
For better depiction of trim, backrests are not shown
in illustration.
Pillar and side trim
13/2/2005
Removing
- Fold seat cushion forward.
- Remove press button - 1 - .
- Loosen trim - 2 - in area of clips - 3 - and
remove.
Installing
- Installation is reverse of removal.
Rear shelf, removing and installing
Removing
Caution!
Disconnect battery ground (GND) strap before working
Pillar and side trim
13/2/2005
on electrical system.
Note:
n
Before disconnecting battery, see note concerning
radio anti-ft coding in Owners Manual.
- Switch ignition off.
- Push backrests forward.
- Disconnect connector - 1 - from auxiliary
brake lights - 2 - .
- Unclip rear shelf - 3 - and remove.
Installing
- Installation is reverse of removal.
Pillar and side trim
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст