Volkswagen Golf / Golf GTI / Jetta. Manual — part 774
Installing
- Installation is reverse of removal.
Upper D-pillar trim, assembly overview (Golf
wagon/Jetta wagon)
1. Bolt
2. Upper D-pillar trim panel
¡
Removing
70-3, Upper D-
pillar trim, removing and
installing (Golf wagon/Jetta
wagon)
3. Clips
¡
Qty. 2
Pillar and side trim
13/2/2005
4. Mounting sleeves
¡
Qty. 2
Upper D-pillar trim, removing and installing
(Golf wagon/Jetta wagon)
Note:
n
Removal and installation is described for right side of
vehicle. same instructions apply for removal and
installation for left-hand side.
Removing
- Remove roof end strip
70-6, Roof end strip, removing
and installing (Golf wagon/Jetta wagon)
.
- Remove bolt - 1 - .
Pillar and side trim
13/2/2005
- Remove trim - 2 - and pull out upward.
Installing
Note:
n
Before installing trim - 2 - , check
clips - 3 - and mounting sleeves - 4 -
for damage, replace if necessary.
n
Steel clips and D-pillar trim parts
can no longer be ordered separately
for vehicles with side curtain
protection
⇒ parts catalog.
- Insert clips - 3 - into mounts for trim - 2 -
and press mounting sleeves - 4 - into C-
pillar holes.
- Insert lower edge of D-pillar trim panel -
Pillar and side trim
13/2/2005
2 - behind luggage compartment side trim
and clip into D-pillar.
- Secure trim - 2 - in roof area with bolt - 1
- .
- Install roof end strip
70-6, Roof end
strip, removing and installing (Golf
wagon/Jetta wagon)
.
Wheel housing trim, removing and installing
(Golf)
Note:
n
Removal and installation is described for right side of
vehicle. same instructions apply for removal and
installation for left-hand side.
Removing
Pillar and side trim
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст