Volkswagen Golf / Golf GTI / Jetta. Manual — part 499
and including 92 kW
¡
With SDI/TDI engine
11. Ball joint
¡
Checking
40-3, Ball joint,
checking
¡
Removing and installing
40-
3, Ball joint, removing and
installing
12. Self-locking hex nut, 45 Nm
¡
Always replace
13. Shield plate
14. Hex bolt, 10 Nm
15. Hex bolt
¡
For special model "Golf GTI
132 kW"
¡
Fastening
40-5, Installing
¡
Always replace
16. Self-locking 12-point nut
¡
Fastening
¡
Always replace
17. Phillips-head screw, 4 Nm
18. Ventilated brake disc
19. Wheel hub with speed sensor
rotor
¡
Rotor is welded to wheel hub
¡
Removing and installing when
the wheel bearing housing is
installed
40-3, Front wheel
bearing, pressing out and in
with wheel bearing housing
installed
Front suspension, servicing
20. Circlip
¡
Make sure it is seated properly
21. Wheel bearing
¡
Pressing out
40-3, Pressing
wheel bearing out of wheel
bearing housing
¡
Replace, as it is destroyed
during pressing out
¡
Pressing in
40-3, Pressing
wheel bearing into wheel
bearing housing
¡
Removing and installing when
the wheel bearing housing is
installed
40-3, Front wheel
bearing, pressing out and in
with wheel bearing housing
installed
22. Wheel bearing housing
¡
With gasoline engines from
110 kW
For vehicles:
Pressing wheel hub out of wheel bearing housing
Front suspension, servicing
Pulling bearing inner race out of hub
Removing circlip
Pressing wheel bearing out of wheel bearing housing
Front suspension, servicing
Greasing hole completely with Molikote grease
Molykote grease, G 052 723 A2
Use grease packet from repair kit
Pressing wheel bearing into wheel bearing housing
- Install circlip.
Note:
n
Make sure the circlip is seated correctly. The opening
of the circlip must point downward.
Front suspension, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст