Volkswagen Golf / Golf GTI / Jetta. Manual — part 500
Pressing wheel hub into wheel bearing
Front wheel bearing, pressing out and in
with wheel bearing housing installed
Special tools, testers and auxiliary items
required
Front suspension, servicing
n
Thrust pad 40 - 105
n
Hub puller 3283
n
Collar for wheel bearing inner race
3423
n
Engine/transmission jack V.A.G
1383 A with universal transmission
mount V.A.G1359/2
n
- 2 - Puller Kukko 18/0
Special tools, testers and auxiliary items required
n
Foot pump with high pressure hose V.A.G1389A/1
If there is a hand pump V.A.G 1389/1 available in the
dealership it can be converted to a foot pump.
To do this use the conversion set V.A.G 1389/4 .
Special tools, testers and auxiliary items required
Special tools, testers and auxiliary items required
n
Hydraulic removal and installing tool for wheel bearing
V.A.G 1459 B
Front suspension, servicing
n
Piston cylinder HKZ-15 with hydraulic press piece E-
0-204-T
n
Removal rods E-0-217+218
n
Special nut E-8-214
n
Press piece E-5
n
Press piece E-10
n
Press sleeve E-13-1
n
Thrust bolt E-15
n
Supplementary set V.A.G 1459 B/2
n
Bell E-40
- Lift vehicle until the load on front axle is relieved.
- Loosen 12-point nut.
- Lift vehicle to installing height.
- Remove wheel.
The following three steps are necessary only for vehicles
with modified stabilizer bar mounting.
Front suspension, servicing
- Loosen upper hex nuts of connecting links from left and
right suspension strut.
- Pull out clamp on brake hose bracket and release brake
hose.
- Release speed sensor wiring from front suspension strut.
- Remove brake carrier with brake caliper. To do this
remove brake caliper and hang from body with wire.
.
Repair Manual, Brake Systems, Repair Group 46,
Servicing front brakes
- Mark installation position of bolts from ball joint to control
arm.
- Remove bolts - Arrows - .
Front suspension, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст