Volkswagen Golf / Golf GTI / Jetta. Manual — part 221
24-138
Checking wiring for Heated
Oxygen Sensor (HO2S)
- Remove wiper arms and cowl
panel:
Repair Manual, Electrical
Equipment; Repair Group 92
- Connect VAG 1598/31 test box to
control module wiring harness.
Engine Control Module (ECM) -
J220- remains disconnected.
- Remove protective cover (arrows)
and disconnect 6-pin connector
(black) -1- to Heated Oxygen
Sensor (HO2S) -G39-.
Functions, checking
24-139
If no wiring malfunction is detected:
- Check wiring for open circuit
between test box and 6-pin
connector (to control module)
referring to Electrical Wiring
Diagrams.
Terminal 1 and socket 70
Terminal 2 and socket 71
Terminal 5 and socket 51
Terminal 6 and socket 52
Wire resistance: max. 1.5
- Additionally check wires all for
short to one another.
Specification:
- Replace Heated Oxygen Sensor
(HO2S) -G39-
Page 24-19
,
item 20 .
- Check DTC memory, repair
malfunctions if necessary and
then erase DTC memory
Page
01-23
.
- Erase learned values and adapt
Motronic Engine Control Module
(ECM) -J220- again
Page 24-
182
.
- Read readiness code
Page 01-
146
. If DTC memory has been
erased or Motronic Engine
Control Module (ECM) -J220- was
disconnected from battery
positive (B+), readiness code
must be generated again
Page
01-149
.
Functions, checking
24-140
Oxygen Sensor (O2S) and Oxygen
Sensor control after Three Way Catalytic
Converter (TWC), checking
Note:
The vehicle must be raised to gain access to
the Oxygen Sensor (O2S) connector.
Only gold plated terminals may be used to
service the terminals in the Oxygen Sensor
(O2S) connectors.
Special tools, materials and equipment
Note:
All functions which could previously be performed
with VAG 1551/1552 can also be performed with
the VAS 5051.
VAG 1551 Scan tool (or VAG 1552) with VAG
1551/3 adapter cable
VAG 1526 or Fluke 83 Hand multimeter or VAG
1715 multimeter
VAG 1594 Adapter set
VAG 1598/31 test box
Electrical Wiring Diagrams
Functions, checking
24-141
Test requirements
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, this must be
switched off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Exhaust system between Three
Way Catalytic Converter (TWC)
and cylinder head must be free
of leaks.
Engine Coolant Temperature
(ECT) must be at least 85 C,
display group 1, display zone
2.
Three Way Catalytic Converter
(TWC) temperature must be at
least 380 C,
display group
34, display zone 2.
Functions, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст