Volkswagen Golf / Golf GTI / Jetta. Manual — part 885
01-316
- Repeat coding.
If the control module cannot be
coded (correct control module,
correct code number), the control
module is malfunctioning.
Ending function:
- Press
button.
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -6- to end
the output.
- Confirm entry with the -Q- button.
Rapid data transfer
Q
06 End output
Indicated on display:
- Switch off ignition.
- Disconnect connector to V.A.G
1551 scan tool.
Central locking system (vehicles without power windows), On Board Diagnostic ...
13/2/2005
01-317
Check DTC Memory
Note:
The vehicle system tester V.A.G 1552 can be
used instead of the V.A.G 1551 scan tool,
however a print-out is not possible.
- Connecting scan tool
Page 01-3
, initiating On
Board Diagnostic (OBD)
Page 01-307
.
- Switch on printer with Print button (warning lamp
in button lights up).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -2- (the function "Check
DTC memory" is entered with 02).
Rapid data transfer
Q
02 - Check DTC memory
Indicated on display:
- Press "Print" button
- Confirm entry with the -Q- button.
X DTCs recognized!
The number of stored malfunctions appears in the
display.
The stored malfunctions are displayed and printed
out one after the other.
Central locking system (vehicles without power windows), On Board Diagnostic ...
13/2/2005
01-318
Note:
If a DTC is recognized:
1 . Repair malfunction
2. Erase DTC memory (function 05).
3. Check DTC memory again (function 02).
- The DTCs printed out can be repaired with aid of
DTC table
Page 01-323
.
- The function "Read Measuring Value Block"
Page 01-347
and Display group overview
Page 01-349
are additional aids.
The measured value block is divided into 10
display group numbers. The assignment of the
individual display zones can be taken from the
display group overview
Page 01-349
.
No DTC recognized!
If "No DTC recognized" is displayed the program
will return to the initial position after pressing the
button.
Rapid data transfer
HELP
Select function XX
Indicated on display:
If something else is displayed:
Scan tool operating instructions
Central locking system (vehicles without power windows), On Board Diagnostic ...
13/2/2005
01-319
- Press buttons -0- and -6- to end
the output.
Rapid data transfer
Q
06 End output
Indicated on display:
- Confirm entry with the -Q- button.
Rapid data transfer
HELP
Enter address word XX
Indicated on display:
- Switch off ignition.
- Disconnect connector to V.A.G
1551 scan tool.
Central locking system (vehicles without power windows), On Board Diagnostic ...
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст