Volkswagen Golf / Golf GTI / Jetta. Manual — part 55
17-13
7 - Oil
pressure
pipe
Coat
cylinder
block and
oil pump
housing
with
sealing
compound
AMV 188
001 02
8 - 8 Nm
9 - Seal
Replace
if
damaged
Lubrication system components, servicing
17-14
Special tools and equipment
Fig. 1
Checking oil pump
backlash
Feeler gauge
Wear limit: 0.20 mm
Special tools and equipment
Fig. 2
Checking oil pump axial
clearance
Straight edge
Feeler gauge
Wear limit: 0.10 mm
Lubrication system components, servicing
17-15
Oil pan, removing and installing
Special tools and equipment
VAG 1331 Torque wrench (5...50 Nm)
D 176 404 A2 Silicone sealing compound
Hand drill with plastic brush attachment
Flat scraper
Protective goggles
Removing
- Remove center, left and right insulation trays:
Repair Manual, Body Exterior, Repair Group
50
- Unscrew bracket for Secondary Air Injection
(AIR) pump motor -V101- from oil pan and from
cylinder block
Page 26-26
, item - 17 -.
- Drain engine oil.
Note:
Observe waste disposal regulations!
- Remove oil pan.
Lubrication system components, servicing
17-16
- If necessary loosen oil pan with light blows of a
rubber mallet.
- Remove sealant residue from cylinder block with
a flat scraper.
Installing
Note:
- Remove sealant residue from pan with a rotating
brush, e.g. a hand drill with a plastic brush
attachment (wear protective goggles).
- Clean sealing surfaces. They must be free of oil
and grease.
Note the expiration date of the sealing
compound.
Oil pan must be installed within 5 minutes of
applying silicone sealing compound.
Lubrication system components, servicing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст