Volkswagen Golf / Golf GTI / Jetta. Manual — part 1112
92-16
Wiper blade contact angle, checking and
adjusting
Notes:
The following procedure is not applicable to the
"Aero-wiper" wiper arm/blade design installed
as a running change during m.y. 2002.
Check wiper blade contact angle on
conventional blades (through m.y. 2001) only if
wiper blades skip, judder or make noise.
Special tools and equipment
Wiper arm setting device 3358B
24 mm open end wrench
Torque wrench
Windshield wiper system
13/2/2005
92-17
- Bring wiper arm to park position.
- Remove wiper blade.
Adjust contact angle to specification,
if required, as follows:
- Insert wiper arm -2- into setting
device and secure with lock screw
-3-.
- Check contact angle.
Contact angle (specification)
Driver's side
- 8.5
Passenger's side
- 1.0
Rear window wiper
0
Tolerance
2
- Place 24 mm open end wrench -
1- on setting device and adjust
wiper arm -2- to specification
(arrows).
- Release wiper arm -2- from
setting device and then re-secure
with lock screw -3-.
Windshield wiper system
13/2/2005
92-18
- Compare adjustment readout with table. If
necessary repeat adjustment.
- Remove setting device and install wiper blade.
Wiper arm tightening torque: 20 Nm (15 ft. lb)
- Check that wiper system operates without
skipping.
Windshield wiper system
13/2/2005
92-19
Windshield wiper system,
tightening torques
Location / Fastener
Tightening torque
Wiper motor to mounting frame / bolts M6 8 Nm
Wiper motor crank to wiper motor / nut M8 20 Nm
Wiper arm to wiper shaft / nut
M8 20 Nm
Windshield wiper system, tightening torques
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст