Volkswagen Golf / Golf GTI / Jetta. Manual — part 1110
92-8
Wiper motor, removing from
frame
Wiper motor, installing in frame
- Lever both linkages -1- from
crank using pry lever 80-200 .
- Remove hex nut -2-.
- Remove crank.
- Remove three mounting bolts -3-.
- Remove motor from frame.
- Ensure wiper motor is in park
position by briefly connecting
electrical connection to wiper
motor, and operating wiper
switch.
- Disconnect electrical connection,
insert wiper motor into frame and
tighten three mounting bolts.
Tightening torque: 8 Nm
- Install crank onto wiper motor
shaft, aligning the linkages so that
they are in-line as illustrated.
Windshield wiper system
13/2/2005
92-9
Wiper assembly, installing
- Tighten crank hex nut -2-.
Tightening torque: 20 Nm
- Press linkages -1- onto crank.
- Install in reverse order of removal,
noting the following:
- Ensure ends of cowl panel are
inserted under cowl panel rubber
strip on A pillar -arrow-
- Reconnect battery
Page 27-
39
.
- Install wiper arms
Page 92-10
.
Windshield wiper system
13/2/2005
92-10
Windshield wiper arms,
removing and installing
Removing
Wiper arms, removing
Page 92-
4
.
Installing
Note:
Wiper arm nuts -1- must be only be
torqued after the wiper blade park
position is adjusted properly.
- Switch ignition on and briefly turn
wipers on and off (wipers must
come to a complete stop)
- Switch off ignition and remove
ignition key.
- Mount wiper arms to wiper shaft
and loosely install nuts -1- (do not
tighten).
- Adjust wiper blade park position
Page 92-11
.
- Reinstall cover caps.
Windshield wiper system
13/2/2005
92-11
Wiper blade park position,
adjusting
Special tools and auxiliary items
needed
VAG 1331 Torque wrench (or
equivalent 5 - 50 Nm)
Windshield wiper system
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст