Volkswagen Golf / Golf GTI / Jetta. Manual — part 218
24-126
Test requirements
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, this must be
switched off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Exhaust system between Three
Way Catalytic Converter (TWC)
and cylinder head must be free
of leaks.
Engine Coolant Temperature
(ECT) must be at least 85 C,
display group 4, display zone
3.
Intake air temperature less than
60 C display group 04,
display zone 4.
Three Way Catalytic Converter
(TWC) temperature must be at
least 380 C,
display group
34, display zone 2.
Functions, checking
24-127
Test sequence
- Connect VAG 1551 Scan tool (or VAG 1552)
and select engine electronics control module
with "Address word" 01. Engine must be running
at idle speed: ((VAG 1551 and Motronic Engine
Control Module (ECM) -J220-, connecting and
selecting
Page 01-12
).
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Then:
- Connect scan tool.
- Continue running engine at idle.
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -4- for function "Initiate
basic setting" and confirm entry with -Q- button.
Basic setting
Input display group number XXX
Indicated on display:
- Press buttons -0-, -0- and -1- for "Display group
number 1" and confirm entry with -Q- button.
Functions, checking
24-128
System in basic setting 1
1
2
3
4
Indicated on display: (1 to 4
display zones)
Note:
In the function "System in basic
setting" the Evaporative Emission
(EVAP) Canister Purge Regulator
Valve -N80- is closed and the air
conditioner compressor turned off.
Checking idle speed
- Check adjustment conditions for
basic settings in display zone 4:
Specification: 11111111
Significance of figures in 8 digit
number block
Page 01-189
.
- Briefly increase engine speed
(rev- up) and then allow engine to
run at idle for 2 minutes.
- Change to display group 56 as
follows:
- Press -C- button.
- Press buttons -0-, -5- and -6- for
"Display group number 56" and
confirm entry with -Q- button.
System in basic setting 56
1
2
3
4
Indicated on display: (1 to 4
display zones)
Functions, checking
24-129
- Check operating conditions in display zone 4:
Specification: xx000
Significance of figures in 5 digit number block
Page 01-240
.
- Check specified idle speed in display zone 2.
Specification: 700 rpm
- Check actual idle speed in display zone 1.
Specification: 640 to 720 rpm
- Press
button.
- Press buttons 0 and 6 for function "End output"
and confirm entry with Q button.
- Switch off ignition.
If the idle speed is not obtained:
- Erase learned values and adapt Motronic
Engine Control Module (ECM) -J220- again
Page 24-182
.
- Road test vehicle.
Observe the valid safety precautions when
performing a road test
Page 24-33
.
Functions, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст