Volkswagen Golf / Golf GTI / Jetta. Manual — part 219
24-130
- Check control module DTC memory again.
- Repeat engine idle speed check.
If the specifications are not obtained again:
- Check Throttle Valve Control Module -J338-
Page 24-59
.
- Check operating condition of engine
Page 24-
158
.
- Check intake air system for leaks (unmetered
air)
Page 24-121
.
- Check signals from / to air conditioning system
Page 24-194
.
Functions, checking
24-131
Oxygen Sensor (O2S) and Oxygen
Sensor control before Three Way
Catalytic Converter (TWC), checking
Note:
The vehicle must be raised to gain access to
the Oxygen Sensor (O2S) connector.
Only gold plated terminals may be used to
service the terminals in the Oxygen Sensor
(O2S) connectors.
The Oxygen Sensor (O2S) before Three Way
Catalytic Converter (TWC) has a continuous
regulation and can be differentiated from the
Oxygen Sensor (O2S) Behind Three Way
Catalytic Converter (TWC) -G130- by its 6
connector.
Special tools, materials and equipment
Note:
All functions which could previously be performed
with VAG 1551/1552 can also be performed with
the VAS 5051.
VAG 1551 Scan tool (or VAG 1552) with VAG
1551/3 adapter cable
VAG 1526 or Fluke 83 Hand multimeter or VAG
1715 multimeter
VAG 1594 Adapter set
Functions, checking
24-132
VAG 1598/31 test box
Electrical Wiring Diagrams
Test requirements
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
If the vehicle is equipped with air
conditioning, it must be turned
off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Exhaust system between Three
Way Catalytic Converter (TWC)
and cylinder head must be free
of leaks.
Engine Coolant Temperature
(ECT) must be at least 85 C,
display group 1, display zone
2.
Three Way Catalytic Converter
(TWC) temperature must be at
least 380 C,
display group
34, display zone 2.
Functions, checking
24-133
Functional check
- Connect VAG 1551 Scan tool (or VAG 1552)
and select engine electronics control module
with "Address word" 01. Engine must be running
at idle speed: ((VAG 1551 and Motronic Engine
Control Module (ECM) -J220-, connecting and
selecting
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -8- for function "Read
measured value (data) block" and confirm entry
with -Q- button.
Read measured value block
Input display group number XXX
Indicated on display:
- Press buttons -0-, -3- and -0- for "Display group
number 30" and confirm entry with -Q- button.
Read measured value block 30
1
2
Indicated on display: (1 to 2
display zones)
- Check Oxygen Sensor control status before
Three Way Catalytic Converter (TWC) (display
zone 1):
Specification: 111
Significance of figures in 3 digit number block
Page 01-217
.
Functions, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст