Volkswagen Golf / Golf GTI / Jetta. Manual — part 1227
Removal/Installation tool T10029
Puller T10095
Torque wrench V.A.G 1331/ (5 - 50 Nm)
Engine code(s) AEG, AVH, AZG, BBW, BEV
- Pry out plugs - arrows - and remove nuts underneath.
- Remove nut - 1 -
- Pull out oil dipstick.
Description of work (part 2 of 2)
13/2/2005
- Remove engine cover.
Spark plugs
VW Part No.
101 000 033 AA
Manufacturer designation
BKUR 6 ET 10 (NGK)
Spark gap
0.9 to 1.1 mm
Tightening torque
30 Nm
- Remove spark plug connector - arrows - using tool
T10029.
- Remove spark plug using Spark plug wrench VAS 3122B
- arrow -
- Install spark plugs with Spark plug wrench VAS 3122B .
- Install spark plug connectors using Removal/Installation
tool T10029
- Check that ignition wiring and spark plug connectors are
seated securely.
- Install engine compartment cover.
Engine code BJS
Perform the following work sequence:
Description of work (part 2 of 2)
13/2/2005
- Unclip and remove cover for wiring guides - 1 - .
- Remove engine cover - 2 - at the indicated points -
arrows - and remove upward.
- Remove connectors for ignition coils with power output
stages - arrows - .
- Unlock the connector locating device with the Assembly
tool T10118 .
- Place the Assembly device T10118 on the connector
locating device - arrow - , and carefully pull the connector
off.
Description of work (part 2 of 2)
13/2/2005
- Push the Remover T10095/a from the straight connector
side, in the direction of the - arrow - , on the ignition coil
with power output stage
- Pull the ignition coil with power output stage up
perpendicularly and out.
- Observe the installed locations of the ignition coils with
power output stages to the connectors, before they are
removed - arrows - .
The straight side of the connector must fit to the straight
side of the ignition coil with power output stage.
- Remove spark plugs with Spark plug wrench VAS 3122B .
Description of work (part 2 of 2)
13/2/2005
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст