Volkswagen Golf / Golf GTI / Jetta. Manual — part 234
24-190
Test sequence
Note:
To check the vehicle speed signal, the vehicle
must be driven. To do this a second person is
necessary.
WARNING!
Secure test equipment to rear seat and
operate it from this position.
- Connect VAG 1551 Scan tool (or VAG 1552)
and select engine electronics control module
with "Address word" 01. Engine must be running
at idle speed: ((VAG 1551 and Motronic Engine
Control Module (ECM) -J220-, connecting and
selecting
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -8- for function "Read
measured value (data) block" and confirm entry
with -Q- button.
Read measured value block
Input display group number XXX
Indicated on display:
- Press buttons -0-, -0- and -5- for "Display group
number 5" and confirm entry with -Q- button.
Additional signals, checking
24-191
Read measured value block 5
1
2
3
4
Indicated on display: (1 to 4
display zones)
Observe the valid safety precautions
when performing a road test
Page
24-33
.
If no speed is indicated or the
display values do not reduce when
driving at a lower speed:
Repair Manual, Electrical
Equipment; Repair Group 92
- Road test vehicle with a 2nd
person to observe display.
- Observe figure displayed in
display zone 3:
Specification: approx. driven
speed
- Drive slower. Displayed value
must decrease.
- Press
button.
- Press buttons -0- and -6- for
function "End output" and confirm
entry with -Q- button.
- Switch off ignition.
- Remove wiper arms and cowl
panel:
Additional signals, checking
24-192
Note:
Front right wheel must not turn, if
necessary, hold to prevent it from
turning.
If the display does not fluctuate:
Electrical Wiring Diagrams,
Troubleshooting & Component
Locations
- Connect VAG 1598/31 test box to
control module wiring harness.
Engine Control Module (ECM) -
J220- remains disconnected.
- Connect multimeter to measure
voltage between test box sockets
1 (Ground) and 54 (vehicle speed
signal) using adapter cables from
VAG 1594.
- Raise vehicle at front left.
- Switch on ignition.
- Rotate front wheel and observe
voltage display.
Specification: 0.0... at least 4.0 V
fluctuating
- Check wiring from test box socket
54 to instrument cluster for
open/short circuit:
Additional signals, checking
24-193
- Check DTC memory, repair malfunctions if
necessary and then erase DTC memory
Page
01-23
.
- Read readiness code
Page 01-146
. If DTC
memory has been erased or Motronic Engine
Control Module (ECM) -J220- was disconnected
from battery positive (B+), readiness code must
be generated again
Page 01-149
.
Additional signals, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст