Volkswagen Golf / Golf GTI / Jetta. Manual — part 235
24-194
A/C compressor signal,
checking
Special tools, materials and
equipment
Note:
All functions which could previously
be performed with VAG 1551/1552
can also be performed with the VAS
5051.
VAG 1551 Scan tool (or VAG
1552) with VAG 1551/3 adapter
cable
VAG 1526 or Fluke 83 Hand
multimeter or VAG 1715
multimeter
VAG 1594 Adapter set
VAG 1598/31 test box
Electrical Wiring Diagrams
Additional signals, checking
24-195
Test requirements
The fuses must be OK.
The battery voltage must be at
least 11.5 V.
All electrical accessories, e.g.
lights and rear window defroster
must be switched off.
Selector lever must be in
position "P" or "N" on vehicles
with an automatic transmission.
Air conditioner functioning OK.
Air conditioner must be turned
off.
Vehicle at room temperature
(warmer than + 15 C).
No Diagnostic Trouble Code
(DTC)s must be stored in DTC
memory
Page 01-23
.
Additional signals, checking
24-196
Test sequence
- Connect VAG 1551 Scan tool (or VAG 1552)
and select engine electronics control module
with "Address word" 01. Engine must be running
at idle speed: ((VAG 1551 and Motronic Engine
Control Module (ECM) -J220-, connecting and
selecting
Page 01-12
).
Rapid data transfer
HELP
Select function XX
Indicated on display:
- Press buttons -0- and -8- for function "Read
measured value (data) block" and confirm entry
with -Q- button.
Read measured value block
Input display group number XXX
Indicated on display:
- Press buttons -0-, -5- and -0- for "Display group
number 50" and confirm entry with -Q- button.
Read measured value block 50
1
2
3
4
Indicated on display: (1 to 4
display zones)
- Check displays in display zones 3 and 4:
Indicated in display zone 3:
A/C-Low
Indicated in display zone 4:
Compr. OFF
Additional signals, checking
24-197
- Switch on air conditioning system.
- Select lowest temperature and highest blower
speed.
The display in display zone 3 must change to:
A/C-High.
The display in display zone 4 must change to:
Compr. ON.
- Press
button.
- Press buttons -0- and -6- for function "End
output" and confirm entry with -Q- button.
- Switch off ignition.
If the displays do not change as described:
- Remove wiper arms and cowl panel:
Repair Manual, Electrical Equipment; Repair
Group 92
Additional signals, checking
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст