Volkswagen Golf / Golf GTI / Jetta. Manual — part 1060

01-148

End Output (function 06)

- Press buttons -0- and -6- to select "End Output"

function 06.

Rapid data transfer

Q

06 - End Output

Indicated on display:

- Press -Q- button to confirm input.

Rapid data transfer

HELP

Enter address word XX

Indicated on display:

- Switch off ignition.

- Disconnect VAG 1551 from Data Link Connector

(DLC).

Data Bus On Board Diagnostic Interface -J533- ('Gateway') m.y. 2000 through m...

13/2/2005

01-149

Gateway, coding (function 07)

When replacing the instrument cluster, the Data
Bus On Board Diagnostic Interface -J533- must
be coded according to vehicle equipment.

Note:

Coding must be performed regardless if the
instrument cluster is new or has been previously
coded (installed in a vehicle).

Initiating coding

- Press buttons -0- and -7- to select "Code Control

Module". function 07.

Rapid data transfer

Q

07 - Code control module

Indicated on display:

- Press -Q- button to confirm input.

Code Control Module

Enter code number XXXXX

(0-32000)

Indicated on display:

Data Bus On Board Diagnostic Interface -J533- ('Gateway') m.y. 2000 through m...

13/2/2005

01-150

- Determine code number using code table

below:

Control Modules on "Powertrain" CAN
Bus

Code:

Automatic transmission

00001

Anti-lock brake system (ABS)

00002

Airbag

00004

Code numbers for all control modules connected
to the CAN-Bus must be added.

Example:

Airbag + ABS + Autom. transmission: 00004 +
00002 + 00001 = 00007

- Use scan tool button pad to enter code

number.

6N0909901 Gateway K <-> CAN 0001

Coding 00007

WSC 00000

Indicated on display (example only):

- Press -Q- button to confirm input.

Rapid data transfer

HELP

Select function XX

Indicated on display:

The tester is again in basic function.

- Press buttons -0- and -6- to select "End Output"

function 06.

Data Bus On Board Diagnostic Interface -J533- ('Gateway') m.y. 2000 through m...

13/2/2005

01-151

Read Measuring Value Block (function
08)

Use this function to observe status of
communication between control modules via the
Powertrain CAN Bus..

The measuring value block is divided into 2
display groups, each containing 4 display fields.

- Connect VAG 1551, select operating mode 1

"Rapid data transfer", switch on ignition and
enter address word 17 "instrument cluster".

- Press -Q- button to confirm input.

- Press

button until "Select function"is

displayed.

Rapid data transfer

HELP

Select function XX

Indicated on display:

- Press buttons -0- and -8- to select "Read

Measuring Value Block" function 08.

Rapid data transfer Q

08 - Read Measuring Value Block

Indicated on display:

- Press -Q- button to confirm input.

Read Measuring Value Block HELP

Enter display group number XXX

Indicated on display:

- Using the Scan Tool (ST) button pad, enter the

required display group number (following
example shows display group 001).

- Press -Q- button to confirm input.

Read Measuring Value Block 1

1

2

3

4

Indicated on display: (1...4

Display fields)

Data Bus On Board Diagnostic Interface -J533- ('Gateway') m.y. 2000 through m...

13/2/2005