Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 270
1.4.2
Sunroof Frame, Removing and Instal‐
ling, Wagon
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Note
At least two technicians are needed for removing and installing
the assembly frame.
Removing
– Remove the headliner. Refer to ⇒ Body Interior; Rep. Gr. 70 ;
Roof Trim Panels; Headliner, Removing and Installing .
– If installed, remove the left and right bolts -9- and remove the
bracket for the screen separator -8-.
– Remove the left and right bolts -6- and the bracket for the
screen separator -5-.
– Remove the left and right nuts -4- and the bracket for the grab
handle -7-.
– Remove the left and right nuts -4- and the bracket for the rear
grab handle -3-.
– Bend down the left and right bracket -2- at the airbag mount
-1- -arrow-.
– Disconnect the water drain hoses from the outlet tubes.
– Disconnect the harness connector to the wiring harness on the
sunroof motor.
– Remove the bolts -2- except for the right and left center bolts.
Note
The frame must now be held by 2 technicians.
– Now remove the remaining bolts.
– Lift the frame -1- out of the vehicle.
Installing
– Lift the frame -1- with two technicians into the vehicle.
– Align the frame -1- using two cylindrical pins (8 mm reversed
drill bit) to the front and rear centering holes -arrows- with re‐
spect to the roof when installing.
– Screw in but do not tighten the bolts -2-.
– Connect all water drain hoses -3-.
– Tighten the bolts labeled with numbers in the indicated order
-1 to 9-.
– Tighten the remaining bolts -arrows- in any order.
Installation is performed in reverse order of the removal.
Tightening Specifications
♦ Refer to
⇒ “1.2.3 Overview - Sunroof, Wagon”, page 199
1.5
Wind Deflector, Removing and Installing
⇒ “1.5.1 Wind Deflector, Removing and Installing, Sedan through
02/2015”, page 215
⇒ “1.5.2 Wind Deflector, Removing and Installing, Sedan from
03/2015”, page 217
⇒ “1.5.3 Wind Deflector, Removing and Installing, Wagon”, page
1.5.1
Wind Deflector, Removing and Instal‐
ling, Sedan through 02/2015
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст