Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 248
2.14
Window Guide, Removing and Installing
Note
♦
The following describes the removal and installation of the left window guide. Removing and installing the
right window guide is identical.
♦
Do not bend the window guide when removing it.
Removing
– Remove the inner window shaft strip. Refer to
⇒ “2.16 Inner Window Shaft Strip, Removing and Installing”,
– Remove the outer window shaft strip. Refer to
⇒ “2.15 Outer Window Shaft Strip, Removing and Installing”,
– Remove the B-pillar trim. Refer to
– Remove the front door window. Refer to
⇒ “5.4 Front Door Window, Removing and Installing”,
.
– Remove the exterior rearview mirror. Refer to
⇒ “7.2 Exterior Rearview Mirror, Removing and Installing”,
.
– Remove the securing pin -2- in direction of -arrow a-.
– Roll the sealing lip on the window guide -1- off the door flange
-3-.
– Remove the window guide -1- from the door mount in direction
of -arrows b and c-.
– Remove the window guide -1- from the door flange -3- evenly
all around in direction of -arrows d-.
Installing
– Spray the window guide with soapy water to make it easier to
install.
– Push the window guide -1- in the door mount in direction of
-arrows a and b-.
– Install the window guide -1- forward moving along the door
flange -3- -c arrows-.
– Pull the sealing lip on the window guide -1- onto the door
flange -3-.
– Push in the securing pin -2- in direction of -arrow d-.
Note
Make sure the window guide -1- fits evenly when installing it (wind noises).
Installation is performed in reverse order of the removal.
2.15
Outer Window Shaft Strip, Removing and Installing
Note
♦
The outer window shaft strip has a metal insert in the center.
♦
If it gets bent, the outer window shaft strip can no longer be straightened out again. It will remain “wavy”.
♦
Therefore the outer window shaft strip must be removed and installed evenly without bending it.
♦
The following describes the removal and installation of the left outer window shaft strip. Removing and
installing the right window shaft strip is identical.
Removing
– Slightly remove the outer window shaft strip -1- evenly from
the door flange -2- in direction of -a arrows-. Do not bend the
strip while doing so.
– Pull the outer window shaft strip -1- out from under the exterior
rearview mirror -3- in direction of -arrow b-.
Installing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст