Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 246
For notes and procedures regarding a door handle with the key‐
less access authorization system. Refer to ⇒ Electrical Equip‐
ment; Rep. Gr. 94 ; Access/Start Authorization .
– Insert the door handle -1- into the bracket at a right angle in
direction of -arrow a-.
For vehicles with a keyless access authorization system, the con‐
nector is brought together when installing the door handle.
– Pivot the door handle -1- into the door in direction of
-arrow b-.
– Push the door handle toward the front in direction of
-arrow c- into the mount in the bracket.
– Always perform a function test with the door open.
2.12
Bracket, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
The following describes the removal and installation of the left bracket. The right side is identical.
Removing
– Remove the front door trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Front Door Trim Panels; Front Door Trim Panel,
Removing and Installing .
– Depending on the version, remove the lock cylinder cap and
the lock cylinder. Refer to
⇒ “2.8 Lock Cylinder Cap, Removing and Installing”,
and
⇒ “2.10 Lock Cylinder, Removing and Installing”, page 112
– Or remove the cap without the lock cylinder. Refer to
⇒ “2.9 Cap without Lock Cylinder, Removing and Installing”,
.
– Remove the door handle. Refer to
⇒ “2.11 Door Handle, Removing and Installing”, page 114
.
– Remove the door inner cover. Refer to
⇒ “2.6 Door Inner Cover, Removing and Installing”,
– Remove the bolt -4- and remove the backing plate -3-.
– Remove the bracket -1- from the front door in direction of
-arrow d-.
Detach the Release Cable.
– Release the retainer -5- and pivot it out of the mount in the
bracket in direction of -arrow a-.
– Remove the pin for the release cable from the mount in direc‐
tion of -arrow b-.
– Remove the release cable -2- from the bracket -1- in direction
of -arrow c-.
Installing
Securing the Release Cable
– Guide the release cable -2- in the bracket -1-.
– Install the release cable bolts in the mount in direction of
-arrow b-.
– Pivot the retainer -5- into the mount in the bracket in direction
of -arrow c- and engage.
– Guide the bracket -1- into the front door in direction of
-arrow a-.
– Install the backing plate -3- and tighten the screw -4-.
Installation is performed in reverse order of the removal.
Tightening Specifications
2.13
Door Lock, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Cylinder Head Bolt Socket - 3410-
Note
♦
The following describes the removal and installation of the left door lock. The right side is identical.
♦
The door window must be closed for the following work procedures.
Removing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст