Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 304
– Thoroughly clean the bumper cover and bracket with cleaning
solution.
Note
Approximately 1 cm of adhesive from the tip should not be applied.
– Lightly sand the inside of the bumper cover -6- and thoroughly
clean it.
– Very thinly apply the adhesive for plastic to the bumper cover
and bracket and let it set for 10 minutes.
– Slide the bracket -8- onto the centering drift -1- and push it
through the bumper cover -6-.
– Slide on the counterholder -4- and lightly tighten the knurled
nut -5-.
– Slide on the clamping clip -3- and position the knurled nut
-2-, but do not tighten.
– All brackets are prepared up to this step.
Note
The adhesive cannot run up to the bend.
– Apply the adhesive as shown in the illustration and tighten the
knurled nut -2-.
– After the minimum curing time, remove all centering drifts.
Minimum Curing Time
Wait 30 minutes for the minimum curing time before performing
any further work on the bumper cover and the brackets.
The bumper cover must stay in place and may not be moved dur‐
ing this time.
2.9
Parallel Parking Assist Bracket, Instal‐
ling
Special tools and workshop equipment required
♦ PDC Holder Tool Set - VAS6614B-
♦ Thermal Clip Bonder Kit - VAS6872-
♦ Thermal Clip Bonder Kit - Hand Set - VAS6872/1-
♦ Thermal Clip Bonder Kit - Clip, M-shaped - VAS6872/3-
Bracket, Installing
Note
After the bumper cover is painted, install the brackets.
The four markings for the bracket -1- are found on the inside of
the bumper cover.
– Drill the holes from the inside outward with the drill -3- supplied
in the tool kit.
– Position the hole stamper with the bolt head -1-, washer -2-
and counterholder -3- on the inside of the bumper cover -5-.
– Position the iron punch -4- almost up to the bumper cover.
– Push the iron punch -4- onto the bumper cover.
– Tighten the hole stamper -1-.
Note
The iron punch -4- must not rotate on the bumper cover paint.
– By turning at the bolt head -1-, the iron punch -4- is pulled
through the bumper cover material -5- -arrows-.
– Remove the hole stamper and stamp the next holes.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст