Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 303
– Remove the bolts -2-.
– Lift the impact member -1- upward in direction of -arrows- from
the tabs -3- in the cross panel.
Installing
– Guide the impact member -1- with the guides -4- from above
downward in direction of -arrows- into the tabs -3- in the cross
panel.
– Tighten the screws -2-.
Tightening Specifications
2.7
Bumper Cover, Servicing
Note
If the bumper cover is damaged, first determine if it is possible to
repair the plastic before installing a new cover.
Refer to ⇒ General Information; Body Repairs, Body Collision
Repair ; Plastic Repair Methods for the description.
2.8
Parking Aid Bracket, Installing
Special tools and workshop equipment required
♦ PDC Holder Tool Set - VAS6614B-
♦ Hand Cartridge Gun - VAS5155-
Materials
Note
For material part numbers. Refer to the Parts Catalog.
♦ 2K plastic adhesive
1)
2)
♦ Plastic adhesive
1)
♦ Cleaning Solution
1)
♦ Primer applicator
1)
1)
Follow the manufacturer's instructions provided in the packag‐
ing.
2)
Note the minimum curing time. Refer to
.
Bracket, Installing
Note
After the bumper cover is painted, install the brackets.
The four markings for the bracket -1- are found on the inside of
the bumper cover.
– Determine the central point -2-, if not already present.
– Drill the holes from the inside outward with the drill -3- supplied
in the tool kit.
– Position the hole stamper with the bolt head -1-, washer -2-
and counterholder -3- on the inside of the bumper cover -5-.
– Position the iron punch -4- almost up to the bumper cover.
– Push the iron punch -4- onto the bumper cover.
– Tighten the hole stamper -1-.
Note
The iron punch -4- must not rotate on the bumper cover paint.
– By turning at the bolt head -1-, the iron punch -4- is pulled
through the bumper cover material -5- in direction of
-arrows-.
– Remove the hole stamper and stamp the next holes.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст