Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 317
– Disconnect the hose -5- and the wire -4-.
For notes on the windshield washer system hose. Refer to ⇒
Electrical Equipment; Rep. Gr. 92 ; Rear Window Washer Sys‐
tem; Overview - Rear Window Washer System .
For notes on the high-mounted brake lamp wire. Refer to ⇒ Elec‐
trical Equipment; Rep. Gr. 94 ; High-Mounted Brake Lamp;
Overview - High-Mounted Brake Lamp .
Installing
– Check the foam rings -1- for the clips, centering pins and
threaded pins for damage, and replace if necessary.
– Check the foam strips -5 and 6- for damage and replace if
necessary.
– Check the felt strips (32 mm x 110 mm) -4- and foam strips (20
mm x 122 mm) -2- on the right and left sides for damage, and
replace if necessary.
– Remove the protective film from the adhesive tape -3- on the
left and right sides.
– Secure the hose -2- and wire -3-.
For notes on the windshield washer system hose. Refer to ⇒
Electrical Equipment; Rep. Gr. 92 ; Rear Window Washer Sys‐
tem; Overview - Rear Window Washer System .
For notes on the high-mounted brake lamp wire. Refer to ⇒ Elec‐
trical Equipment; Rep. Gr. 94 ; High-Mounted Brake Lamp;
Overview - High-Mounted Brake Lamp .
– Bring the spoiler on the edge of the roof -1- into the installation
position using the centering pin -7-.
– Push the spoiler on the edge of the roof -1- forcefully onto the
rear lid -arrows-, until the clips -8- engage.
– Place the hex nuts -6- on the threaded pins -5- and tighten.
Installation is performed in reverse order of the removal.
Tightening Specifications
2.3
Side Spoiler, Removing and Installing
Removing
Special tools and workshop equipment required
♦ Wiring Harness Repair Set - Hot Air Blower - VAS1978/14A-
Note
♦
The illustration shows the left side. The right side is identical.
♦
When removing the side spoiler the adhesive tapes are damaged.
♦
When using new specified adhesive tape the side spoiler can be reused.
– Warm the side spoiler -1- in the area of the adhesive strips
-2- using a -VAS1978/14A- .
– Remove the side spoiler -1- from the rear window and remove
downward from the spoiler on the edge of the roof -4-
-arrows-.
Installing a New Side Spoiler
Special tools and workshop equipment required
♦ Professional Cleaning Cloth - VAS6006-
Note
♦
The illustration shows the left side. The right side is identical.
♦
The side spoiler -1- is attached with two-sided adhesive tape -2-.
– Place the side spoiler -1- on the rear window and mark the
position -3- with adhesive tape.
– Remove the side spoiler -1-.
– Clean the rear window at the marked areas -3- with cleaning
solution.
Note
♦
The application with help of the primer applicator must be performed in one step without stopping.
♦
A closed film must be produced on the glass surface.
♦
Avoid applying twice.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст