Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 318
– Apply the colorless glass/paint primer evenly on the adhesive
surface -3- on the rear window and lightly wipe off using the -
VAS6006- .
Glass/paint primer drying time: five minutes.
– Peel off the protective film from the double-sided adhesive
tape -2-.
– Push the side spoiler -1- under the spoiler on the edge of the
roof -4- -arrows- and align.
– Push the side spoiler -1- forcefully in the rear window.
Installing the Removed Side Spoiler
Note
♦
If a removed spoiler is reused, the adhesive tape must be self-prepared.
♦
Use the adhesive tape from the allocation. Refer to the Parts Catalog.
– Remove the adhesive residue completely.
– Clean the spoiler -4- thoroughly with the cleaning solution.
– Prim the adhesive surface -3- evenly and in a single stroke.
Glass/paint primer drying time: five minutes.
– Cut the adhesive tape -3- as shown.
– At the same time leave a pull tab dimension -a- from the pro‐
tective film -2- on all adhesive tapes.
– The further installation is performed the same as a new spoiler.
3
Molding/Trim/Extensions/Trim Pan‐
els
⇒ “3.1 Overview - Drip Rail”, page 406
⇒ “3.2 Overview - Side Sill Trim Panel”, page 408
⇒ “3.3 Overview - Heat Shield”, page 409
⇒ “3.4 Drip Rail, Removing and Installing”, page 409
⇒ “3.5 Side Sill Trim Panel, Removing and Installing”, page 411
⇒ “3.6 Front Door B-Pillar Trim, Removing and Installing”,
page 414
⇒ “3.7 Rear Door B-Pillar Trim, Removing and Installing”,
page 415
⇒ “3.8 Rear Door C-Pillar Trim, Removing and Installing”,
page 417
⇒ “3.9 Floor Heat Shield, Removing and Installing”, page 418
⇒ “3.10 Center Exhaust System Heat Shield, Removing and In‐
stalling”, page 420
⇒ “3.11 Rear Muffler Heat Shield, Removing and Installing”, page
3.1
Overview - Drip Rail
Note
The illustration shows the right side. The left side is identical.
1 - Drip Rail
❑ Removing and instal‐
ling. Refer to
2 - Retaining Strip
– When removing, drill out
the rivet heads and drive
out the rivet shafts.
3 - A-Pillar
4 - Pop Rivet
❑ Quantity: 5
❑ Install with the Pop Rivet
Nut Pliers - VAS5072A-
5 - Clip
❑ Position the clip in the
fender opening and
push forward, and turn
90°.
6 - Fender
❑ Removing and instal‐
ling. Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст