Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 994
Troubleshooting
The mobile online services system is capable of self-diagnosis
(OBD).
Fault finding is performed via
Guided Fault Finding
on the
Vehicle Diagnostic Tester .
When there are concerns about the function, it necessary to be
familiar with the Mobile Online Services functions.
For additional information. Refer to the Owner's Manual and
⇒ Wiring diagrams, Troubleshooting & Component locations.
10.2
Component Location Overview - Mobile Online Services
Note
The component location is shown for the sedan. The component location for the wagon is identical.
1 - Control Module for Emer‐
gency Call Module and Com‐
munication Unit - J949-
❑ Behind the Instrument
Cluster - KX2-
❑ Removing and instal‐
ling. Refer to
.
❑ Connector assignment.
Refer to ⇒ Wiring dia‐
grams, Troubleshooting
& Component locations.
2 - Front Information Display
Control Head - J685-
❑ In the front center con‐
sole
❑ Removing and instal‐
ling. Refer to
.
3 - Telephone Microphone -
R38-
❑ in the Front Interior
Lamp - W1-
❑ Removing and instal‐
ling. Refer to
4 - Roof Antenna - RX5-
❑ Removing and installing. Refer to
⇒ “3.5 Roof Antenna, Removing and Installing”, page 35
5 - GSM Antenna 2 - R267-
❑ Behind the rear bumper trim panel on the left side
❑ Remove and install like the Vehicle GPS Antenna 2 - R260- . Refer to
⇒ “3.6.2 Vehicle GPS Antenna 2 R260 , Removing and Installing, GSM”, page 37
.
6 - Information Electronics Control Module 1 - J794-
❑ Installed in the glove compartment
❑ Connector assignment. Refer to ⇒ Wiring diagrams, Troubleshooting & Component locations.
❑ Removing and installing. Refer to
⇒ “1.4 Information Electronics Control Module 1 J794 , Removing and Installing”, page 13
.
7 - Instrument Cluster - KX2-
❑ Removing and installing. Refer to ⇒ Electrical Equipment; Rep. Gr. 90 ; Instrument Cluster; Instrument
Cluster - KX2- , Removing and Installing .
10.3
Control Module for Emergency Call
Module and Communication Unit -
J949- , Removing and Installing
If the control module is replaced, select the
Replacement
func‐
tion for the appropriate control module in
Guided Fault Find-
ing
using the Vehicle Diagnostic Tester .
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the Instrument Cluster - KX2- . Refer to ⇒ Electrical
Equipment; Rep. Gr. 90 ; Instrument Cluster; Instrument Clus‐
ter - KX2- ; Removing and Installing .
– Disconnect the connectors -1- and -2-.
– Press the catches upward opposite of the -A arrows- and slide
the Control Module for Emergency Call Module and Commu‐
nication Unit - J949- -3- out toward the rear -arrow B-.
Installing
Install in reverse order of removal.
11
Special Tools
Special tools and workshop equipment required
♦ Radio Removal Tool - T10057-
♦ Lever - Fuel Line - T10468-
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
♦ Fiber-Optic Repair Set - Connector Protective Caps -
VAS6223/9-
♦ Torque Screwdriver - VAS6494-
♦ Door Trim Pliers - 3392-
♦ Trim Removal Wedge - 3409-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст