Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 892
– Remove the hex nut -1- from the right and left coupling rod
-3-.
– Remove the coupling rod -3- from the stabilizer bar -2- on the
left and right sides.
– Remove the nuts -arrows- on the left and right side of the ve‐
hicle.
– Remove the control arm from the ball joint.
– Loosen the nut from the tie rod end, but do not unscrew yet.
Caution
To protect the thread, screw the nut on the pin a few turns.
– Remove the tie rod end from the wheel bearing housing and
remove the nut.
1 - -T10187-
Vehicles with Level Control System Sensor
– Disconnect the connector -1- from the Left Front Level Control
System Sensor - G78- or Right Front Level Control Sensor -
G289- .
Continuation for all Vehicles
– Disconnect the connector -1- for the Oil Level Thermal Sensor
- G266- .
– If equipped, disconnect the connector -2- from the After-Run
Coolant Pump - V51- . To do so, open the catch -3- in the
direction of the -arrow- and release the connector.
– Remove the clips -1- and -2- for the wiring harness -3- from
the subframe and the steering gear.
– Remove the steering gear bolts -1-.
– Place the -VAS6931- -1- under the subframe.
– Secure the subframe and lower it approximately 10 cm.
– Remove the bolts -arrows- and remove the heat shield -1- from
the steering gear.
Note
Different heat shields -1- are installed depending on the engine.
On some engine versions, the connectors for the steering gear
are accessible without having to remove the heat shield.
– Disconnect the connectors -1 and 2- from the steering gear.
– Unclip the wiring harness -1- from the steering gear -2-
-arrows-.
– Remove the expanding clip -arrow-.
– Lower the subframe using the -VAS6931- .
– Pry the steering gear off of the subframe, for example, using
a large screwdriver and remove it toward the rear.
– Set the steering gear down as illustrated.
Avoid damage to the control module -1-.
Installing
Install in reverse order of removal. Note the following:
The steering gear threaded sleeves must be seated in the sub‐
frame holes.
– Connect the connectors -1 and 2- so that they audibly click into
place.
Note
♦
Coat the seal on the steering gear with lubricant such as soft
soap before installing the steering gear.
♦
After attaching steering gear to drive axle, make sure that seal
on steering gear is positioned on the mounting plate without
and kinks and is sealed correctly. The opening to the foot well
must sealed correctly. Ingress of water and/or noises may be
the result.
♦
Make sure sealing surfaces are clean.
– Position the steering gear on the subframe.
– Attach the bolts for the steering gear and the stabilizer bar.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст