Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 346
– Remove the screws -1- from the lower steering column trim
panel. To do so, turn the steering wheel accordingly.
– Remove the lower steering column trim panel -2- from the
steering column.
– For vehicles with keyless locking and starting system, discon‐
nect the connector for the Anti-Theft Immobilizer Reader Coil
- D2- .
Installing
Note
Check all the fasteners for damage and replace if necessary.
Install in reverse order of removal.
Tightening Specifications
♦ Refer to
1.13
Front Passenger Side Footwell Cover,
Removing and Installing
Removing
– Remove the bolts -1-.
– Guide the front passenger side footwell cover -2- out of the
instrument panel and center console and remove it.
Installing
Note
♦
Check all the fasteners for damage and replace if necessary.
♦
The screws -1- are installed hand-tight.
Install in reverse order of removal.
1.14
Glove Compartment Handle, Removing
and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Removing
– Open the glove compartment.
– Remove the bolt -1- and the unlock button -2- from the glove
compartment lid.
Installing
Install in reverse order of removal.
Tightening Specifications
Component
Tightening Specification
Release button to glove com‐
partment lid
1.5 Nm
1.15
Glove Compartment Lid Service Posi‐
tion
Moving into Service Position
– Open the glove compartment lid -2-.
– Press the stops -1- for the glove compartment lid -2- upward
in direction of -arrows A -.
– At the same time, open the glove compartment lid farther -2-
in direction of -arrow B-. While doing so, remove the braking
element for the dampening mechanism carefully from the
damper.
Service Position, Resetting
– Slowly close the glove compartment lid while inserting the
braking element for the braking component carefully into the
insulation component.
– Close the glove compartment lid farther and lock behind the
end stops.
1.16
Glove Compartment Lid Dampening
Mechanism, Removing and Installing
Removing
– Move the glove compartment lid into the service position. Re‐
fer to
⇒ “1.15 Glove Compartment Lid Service Position”, page 35
.
– Disconnect the connector -2- from the Glove Compartment
Lamp Switch - E26- -3-.
– Turn the damper -1- 90° (
1
/4 turn) -arrow- and remove it from
the glove compartment.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст