Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 274
Caution
A visual inspection when the sliding sunroof is open on the
vehicle is essential to order the correct replacement part. Refer
⇒ “1.1 Characteristics - Sliding Sunroof, Sedan”, page 193
Removing
Note
♦
For clarity the headliner is not shown in the illustration..
♦
The headliner is not removed.
♦
The bolts in the inner section are slightly covered by a rubber strip -2-.
♦
Do not damage the rubber strip -2-.
– Open the sun shade all the way.
– Tilt the Panorama tilting sunroof glass panel open.
– Remove the center bolts on the inside -arrows-.
– Open the Panorama tilting sunroof glass panel -arrow A-.
– Remove the rear bolts -arrow-.
– Remove the inner front bolts on the left and right side
-arrow-.
– Only loosen the outer front bolts on the left and right side
-arrow-.
– Remove the glass panel -1- upward.
Note
Close the mechanism with the button in order to avoid damage during further work.
Installing
Note
Screws are microencapsulated and must always be replaced after removing.
Open the mechanism with the button.
– Position the glass panel -1- on the tilting mechanism -2-.
– Only tighten the front and rear bolts -arrows- slightly.
Tilt the Panorama tilting sunroof glass panel open.
– Only tighten the center bolts -arrows- on the left and right side
slightly.
– Adjust the Panorama tilting sunroof glass panel (height ad‐
justment). Refer to
⇒ “1.8 Glass Panel, Adjusting”, page 241
.
Note
Tighten the bolts after the panel height adjustment.
Tightening Specifications
♦ Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст