Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 273
Caution
A visual inspection when the sliding sunroof is open on the
vehicle is essential to order the correct replacement part. Refer
⇒ “1.1 Characteristics - Sliding Sunroof, Sedan”, page 193
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ Bolts - Panorama Sunroof Glass Panel
♦ Bolts - Roof to Slotted Guide Rail Guide
Removing
Note
♦
The headliner is not shown in the illustration for a better view.
♦
The headliner is not removed.
– Open the sun shade all the way.
– Contrary to -arrow a- push the trim -1- slightly to the rear.
– Remove the trim -1- from the sunroof frame -2- -arrow b-.
– Open the Panorama sunroof glass panel 150 mm
-dimension a-
– Remove the rear bolts -2-.
– Loosen the center left and right bolts -4-, but do not remove.
– Remove the left and right front bolt -3-.
– Remove the glass panel -1- upward.
Note
Close the mechanism with the button in order to avoid damage during further work.
Installing
Note
Screws are microencapsulated and must always be replaced after removing.
– Open the mechanism 150 mm -dimension a- with the button.
– Position the glass panel -1- on the tilting mechanism.
– Only lightly tighten the left and right screws -2, 3, and 4-.
– Adjust the Panorama sunroof glass panel (height adjustment).
Refer to
⇒ “1.8 Glass Panel, Adjusting”, page 241
.
Note
Tighten the screws -2, 3 and 4- after the panel height adjustment.
Tightening Specifications
Note
♦
The headliner is not shown in the illustration for a better view.
♦
The headliner is not removed.
– Insert the trim -1- into the sunroof frame -2- in direction of
-arrow a-.
– Push the trim -1- slightly toward the rear in direction of
-arrow b-.
1.6.2
Glass Panel, Removing and Installing,
Sedan from 03/2015
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст