Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 543
5
Technical Data
5.1
Refrigerant R134a Capacities
Complete R134a refrigerant capacity. Refer to Fluid Capacity
book.
5.2
Refrigerant Oil
Important Information
Refrigerant oil is hygroscopic (attracts moisture). Close any
opened containers immediately after use to prevent moisture from
entering.
Note
♦
The special refrigerant oil (for use with refrigerant circuits
R134a only) is no longer obtainable on the refrigerant/machine
oil market.
♦
Do not use refrigerant oil that was stored for long periods of
time in open containers.
Refrigerant Oil Can be Obtained Using Following Part Number;
For:
6SES14C; Denso
G 052 300 A2
11PXE14; Sanden
G 052 154 A2
6CVC140; Delphi
G 052 154 A2 / G 052 300
A2
Complete R134a refrigerant capacity. Refer to Fluid Capacity
book.
5.3
Oil Distribution
The oil, which is located in the sump of the Air Conditioning (A/C)
compressor before initially switching on the air conditioner sys‐
tem, is distributed through the refrigerant circuit as follows:
♦ A/C compressor approximately 50%
♦ Condenser approximately 10%
♦ Suction hose approximately 10%
♦ Evaporator approximately 20%
♦ Receiver/dryer approximately 10%
80 – Heating, Ventilation
1
Component Location Overview -
Heating
⇒ “1.1 Component Location Overview - Components Outside of
Passenger Compartment”, page 9
⇒ “1.2 Component Location Overview - Components Inside Front
Passenger Compartment”, page 10
1.1
Component Location Overview - Components Outside of Passenger Com‐
partment
1 - Vehicle Interior Forced Air
Extraction
❑ Check using the Vehicle
Diagnostic Tester . Re‐
fer to
.
❑ Removing and instal‐
ling. Refer to
2 - Outside Air Temperature
Sensor - G17-
❑ Removing and instal‐
ling. Refer to
.
3 - Fresh Air Intake Cover
❑ Removing and instal‐
ling. Refer to
4 - Fresh Air Intake
❑ Removing and instal‐
ling. Refer to
.
1.2
Component Location Overview - Components Inside Front Passenger
Compartment
1 - Driver Side Footwell Vent
❑ Removing and instal‐
ling. Refer to
❑ Overview. Refer to
2 - Temperature Regulator
Door Motor - V68-
❑ Removing and instal‐
ling. Refer to
.
3 - Air Distribution Door Motor
- V428-
❑ Removing and instal‐
ling. Refer to
.
4 - Dust and Pollen Filter
❑ Removing and instal‐
ling. Refer to
⇒ “4.11 Dust and Pollen Filter, Removing and Installing”, page 92
5 - Recirculation Door Motor - V113-
❑ Removing and installing. Refer to
⇒ “7.4 Recirculation Door Motor V113 , Removing and Installing”, page 134
6 - Fresh Air Blower - V2-
❑ Removing and installing. Refer to
⇒ “4.12 Fresh Air Blower V2 , Removing and Installing”, page 95
.
7 - Front Passenger Side Footwell Vent
❑ Removing and installing. Refer to
⇒ “5.6 Front Passenger Side Footwell Vent, Removing and Installing”, page 117
❑ Overview. Refer to
⇒ “5.1 Overview - Air Routing and Air Distribution in Passenger Compartment”, page 113
8 - Auxiliary Heater Heating Element - Z35- with Auxiliary Air Heater Control Module - J604-
❑ Checking. Refer to
❑ Removing and installing. Refer to
.
9 - Heater Core
❑ Removing and installing. Refer to
⇒ “4.15 Heater Core, Removing and Installing”, page 98
10 - Display and Control Head
❑ Removing and installing. Refer to
⇒ “6.2 Display and Control Head, Removing and Installing”, page 126
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст