Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 334
10.4
Release Cable, Removing and Installing
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ Nut - Gear Mechanism to Trailer Hitch
♦ Bolt - Gear Mechanism to Trailer Hitch
♦ Bolts - Cover
♦ Cover
Removing
WARNING
No other bolts may loosened except for the ones specified.
Do not perform any other work than those described.
Note
♦
The trailer hitch is not completely removed.
♦
The bolts -10 - have a special construction that make removing them more difficult.
– Loosen the trailer hitch and pull out slightly. Refer to
⇒ “10.3 Trailer Hitch, Removing and Installing”, page 462
– Remove the bolts -10- using pliers and remove the cover -9-.
– Turn the turntable -8- slightly and remove the release cable
-7-.
– Loosen the bolt -5- and hex nut -1- and remove the transmis‐
sion -3- with both release cables -2 and 7-.
Installing
Note
♦
There are always new bolted connections -1, 5, and 8- and a new cover -9- to be used.
♦
The cap -6- must not be damaged and must be installed.
♦
Clean the area where the seal is before positioning the cover.
♦
Water must not leak into the swiveling mechanism.
♦
Before installing the trailer hitch on the vehicle, a function test must be performed.
– Secure the gear mechanism -3- with a new bolt -5-, washer
-4- and hex nut -1-.
– Engage the release cable -7- in the turntable.
– Secure the new cover -9- with new bolts -8-.
11
Special Tools
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Engine and Gearbox Jack - VAS6931-
♦ Wiring Harness Repair Set - Hot Air Blower - VAS1978/14A-
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст