Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 333
Install in reverse order of removal. Note the following:
DANGER!
The bolts -4- are actually sealing threaded connections and
seal off the vehicle interior from exhaust gas. They must always
be installed.
The grommet -3- on the release cable must be attached correctly
in the cross panel.
– Perform a function test after installing the trailer hitch.
Tightening Specifications
10.3.2
Trailer Hitch, Removing and Installing,
Wagon
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ Bolt - Trailer Hitch to Body (Always replace after loosening)
Note
Depending on the version, slight deviations must be considered.
Removing
– Loosen the locking mechanism with a screwdriver -3- in di‐
rection of -arrow a-.
– Remove the screwdriver in direction of -arrow b-.
– Slide the locking mechanism upward in direction of -arrow c-.
– Remove the mechanism -1- from the release cable -4- in di‐
rection of -arrow d-.
– Remove the bumper cover. Refer to
⇒ “2.5.2 Bumper Cover, Removing and Installing, Wagon”,
.
– The locking mechanism -7- is loosened.
– Remove the release lever -6- from the release cable -2- in di‐
rection of -arrow A-.
Remove the lock carrier trim panel. Refer to ⇒ Body Interior; Rep.
Gr. 70 ; Luggage Compartment Trim Panels; Lock Carrier Trim
Panel, Removing and Installing .
– Remove the release cable -2- with the guide -3- between the
lock carrier plates in direction of -arrow C-.
– Remove the release cable with the grommet -3- from the ve‐
hicle.
– Disconnect the wire behind the forced air extraction and pull
out of the vehicle.
– Remove the screws -5-.
– Remove the trailer hitch -1- parallel from the longitudinal mem‐
bers.
Installing
Install in reverse order of removal while paying attention to the
following:
DANGER!
The bolts -2- are actually sealing threaded connections and
seal off the passenger compartment from exhaust gas. They
must always be installed.
Note
♦
The grommet on the release cable -3- must be attached correctly in the cross panel.
♦
The locking mechanism -6- must noticeably engage.
– Perform a function test after installing the trailer hitch.
Tightening Specifications
♦ Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст