Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 296
1.3
Overview - Impact Member
1 - Impact Member
2 - Bolt
❑ 8 Nm
❑ Quantity: 2 on each side
3 - Bolt
❑ 55 Nm
❑ Quantity: 4 on each side
4 - Foam Piece
❑ Self-adhesive
❑ Not installed in all model
versions
5 - Butyl Strips
❑ Quantity: 3 with adhe‐
sive film
1.4
Overview - Guides
1 - Side Guide
❑ Left and right
2 - Bolt
❑ Quantity: 1 on each side
❑ Tightening specifica‐
tion. Refer to ⇒ Electri‐
cal Equipment; Rep. Gr.
94 ; Headlamp; Over‐
view - Headlamp .
3 - Nut
❑ 2 Nm
❑ Quantity: 2 on each side
4 - Center Guide
5 - Right Partition
❑ Clipped in the center
guide -4-.
6 - Bolt
❑ 8 Nm
❑ Quantity: 3
7 - Left Partition
❑ Clipped in the center
guide -4-.
1.5
Bumper Cover, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1783 - 2-10Nm - VAG1783-
Note
Depending on the model version, slight deviations of the front bumper cover must be considered when removing
and installing.
Removing
– Remove the radiator grille. Refer to
⇒ “1.2 Radiator Grille, Removing and Installing”, page 396
.
– Remove the bolts -2- in the wheel housing (pointing upward)
on the left and right sides.
– Remove the left and right bolts -3-.
– Remove the bolts -4- from underneath.
A second technician is required for the rest of the removal pro‐
cedure.
– Pull the bumper cover -1- out of the guide catches on the left
and right sides of the fender in direction of -a arrows-.
– Loosen the hooks in direction of -b arrows- from the lock car‐
rier.
– Remove the bumper cover -1- parallel from the vehicle in di‐
rection of -c arrows-.
– Disconnect the hose coupling for the washer fluid hoses
(where applicable). Refer to ⇒ Electrical Equipment; Rep. Gr.
92 ; Headlamp Washer System; Overview - Headlamp Wash‐
er System .
– Disconnect the connectors for the electrical components
(where applicable).
For notes and procedures regarding the parking aid. Refer to ⇒
Electrical Equipment; Rep. Gr. 94 ; Parking Aid .
For notes and procedures regarding the parallel parking assis‐
tance. Refer to ⇒ Electrical Equipment; Rep. Gr. 94 ; Parallel
Parking Assist .
Installing
Installation is only possible with a second technician.
– Connect the connectors of any components.
Note
When positioning the bumper cover, make sure that the front wheel housing liner is seated correctly.
– Guide the bumper cover -1- parallel onto the lock carrier in
direction of -a arrows-, until the hooks engage.
– Push the bumper cover -1- into the side guides -5- on the left
and right of the fender until they engage in direction of
-arrow b-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст