Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 240
Note
♦
The following describes adjusting the left front door. Adjusting the right front door is identical.
♦
When closing, the front door must latch completely without additional force and it must not have any play.
♦
The front door must not be pushed up or down when adjusting the catch.
The alignment of the front door to the side panel or the rear door
can be adjusted via the catch in direction of -arrows a- and
-arrows b- (wind noise).
– Loosen the bolts -3- on the B-pillar to loosen the catch -2-.
Note
More force is needed to move the catch -2- when the bolts -3- are loose.
– Tighten the bolts -3- of the catch -2-.
Tightening Specifications
Component
Tightening Specification
Striker pin to the body
20 Nm
1.7
Door Arrester, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Note
The following describes the removal and installation of the left door arrester. The right side is identical.
Removing
– Remove the front door trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Front Door Trim Panels; Front Door Trim Panel,
Removing and Installing .
– Remove the self-adhesive cover, or the front speaker. Refer
to ⇒ Communication; Rep. Gr. 91 ; Sound System; Left and
Right Front Bass Speaker -R21- / -R23- , Removing and In‐
stalling .
– Remove the bolt -2- from the A-pillar.
– Remove the bolts -3- and remove the door arrester -1- through
the speaker opening -arrow a-.
Installing
Install in reverse order of removal. Note the following:
When no speaker is installed the cover must be installed correctly
and air tight.
Tightening Specifications
Refer to
2
Door Components
⇒ “2.1 Overview - Door Components”, page 95
⇒ “2.2 Overview - Window Regulator”, page 97
⇒ “2.3 Overview - Door Handle and Door Lock”, page 98
⇒ “2.4 Window Regulator Motor, Removing and Installing”,
page 99
⇒ “2.5 Window Regulator, Removing and Installing”, page 101
⇒ “2.6 Door Inner Cover, Removing and Installing”, page 104
⇒ “2.7 Catch, Removing and Installing”, page 106
⇒ “2.8 Lock Cylinder Cap, Removing and Installing”, page 106
⇒ “2.9 Cap without Lock Cylinder, Removing and Installing”, page
108
⇒ “2.10 Lock Cylinder, Removing and Installing”, page 112
⇒ “2.11 Door Handle, Removing and Installing”, page 114
⇒ “2.12 Bracket, Removing and Installing”, page 116
⇒ “2.13 Door Lock, Removing and Installing”, page 119
⇒ “2.14 Window Guide, Removing and Installing”, page 124
⇒ “2.15 Outer Window Shaft Strip, Removing and Installing”, page
126
⇒ “2.16 Inner Window Shaft Strip, Removing and Installing”, page
129
⇒ “2.17 Outer Cover, Removing and Installing”, page 130
2.1
Overview - Door Components
Note
The illustration shows the left side. The right side is identical.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст