Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 55
11
Automatic Headlamp Range Control
⇒ “11.1 Overview - Automatic Headlamp Range Control”,
page 209
⇒ “11.1.2 Overview - Automatic Headlamp Range Control, Wag‐
on”, page 210
⇒ “11.2 Control Module for Headlamp Range/Cornering Lamp
and Headlamp Range, Removing and Installing”, page 211
11.1
Overview - Automatic Headlamp Range
Control
⇒ “11.1.1 Overview - Automatic Headlamp Range Control, Se‐
dan”, page 209
⇒ “11.1.2 Overview - Automatic Headlamp Range Control, Wag‐
11.1.1
Overview - Automatic Headlamp Range Control, Sedan
1 - Expanding Clip
❑ Quantity: 2
2 - Control Module
❑ Without cornering
lamps: Headlamp
Range Control Module -
J431-
❑ With cornering lamps:
Cornering Lamp and
Headlamp Range Con‐
trol Module - J745-
❑ Removing and instal‐
ling. Refer to
.
3 - Connector
4 - Left Rear Level Control Sys‐
tem Sensor - G76-
❑ On the rear control arm
❑ Overview. Refer to ⇒
Suspension, Wheels,
Steering; Rep. Gr. 43 ;
Level Control System
Sensor; Overview -
Rear Level Control Sys‐
tem Sensor .
5 - Left Front Level Control
System Sensor - G78-
❑ On the control arm in the
front
❑ For HID headlamp with
cornering lamp
❑ Overview. Refer to ⇒ Suspension, Wheels, Steering; Rep. Gr. 43 ; Level Control System Sensor; Over‐
view - Front Level Control System Sensor .
6 - Left Headlamp Beam Adjustment Motor - V48-
❑ Removing and installing. Refer to
⇒ “1.8 Left/Right Headlamp Beam Adjustment Motor V48 / V49 , Removing and Installing”, page 111
7 - Right Headlamp Beam Adjustment Motor - V49-
❑ Removing and installing. Refer to
⇒ “1.8 Left/Right Headlamp Beam Adjustment Motor V48 / V49 , Removing and Installing”, page 111
11.1.2
Overview - Automatic Headlamp Range Control, Wagon
1 - Expanding Clip
❑ Quantity: 2
2 - Control Module
❑ Without cornering
lamps: Headlamp
Range Control Module -
J431-
❑ With cornering lamps:
Cornering Lamp and
Headlamp Range Con‐
trol Module - J745-
❑ Removing and instal‐
ling. Refer to
3 - Connector
4 - Left Rear Level Control Sys‐
tem Sensor - G76-
❑ On the rear control arm
❑ Overview. Refer to ⇒
Suspension, Wheels,
Steering; Rep. Gr. 43 ;
Level Control System
Sensor; Overview -
Rear Level Control Sys‐
tem Sensor .
5 - Left Front Level Control
System Sensor - G78-
❑ On the control arm in the
front
❑ For HID headlamp with
cornering lamp
❑ Overview. Refer to ⇒ Suspension, Wheels, Steering; Rep. Gr. 43 ; Level Control System Sensor; Over‐
view - Front Level Control System Sensor .
6 - Left Headlamp Beam Adjustment Motor - V48-
❑ Removing and installing. Refer to
⇒ “1.8 Left/Right Headlamp Beam Adjustment Motor V48 / V49 , Removing and Installing”, page 111
7 - Right Headlamp Beam Adjustment Motor - V49-
❑ Removing and installing. Refer to
⇒ “1.8 Left/Right Headlamp Beam Adjustment Motor V48 / V49 , Removing and Installing”, page 111
11.2
Control Module for Headlamp Range/
Cornering Lamp and Headlamp Range,
Removing and Installing
If the control module is being replaced, use the Vehicle Diagnostic
Tester and select the “Replacing” function for the respective con‐
trol module in “Guided Fault Finding”.
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the driver side instrument panel cover. Refer to ⇒
Body Interior; Rep. Gr. 68 ; Storage Compartments and Cov‐
ers; Driver Side Instrument Panel Cover, Removing and In‐
stalling .
– If installed, remove the driver side knee airbag. Refer to ⇒
Body Interior; Rep. Gr. 69 ; Knee Airbags; Overview - Knee
Airbag .
– Release and remove the expanding clip -3-.
– Remove the control module -1- rearward.
– Release and disconnect the connector -2-.
– To do this push the tab -1-, pivot the retaining bracket in the
direction of -arrow- and remove the connector.
Installing
Install in the reverse order of removal while paying attention to
the following:
– Push the expanding clip -2- in the opening -3- on the control
module -1-.
– Lock the expanding clip by turning 90° in direction of -arrow-.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст