Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 233
Installing
– Insert the actuator -1- into the rear lid -3- in direction of
-arrow a- and turn it slightly in direction of -b arrows-.
– Secure the water drain hose -4- on the actuator in direction of
-arrow c-.
– Tighten the bolts -5-.
– Secure the connectors -6-.
– Install the rear lid lower trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Luggage Compartment Trim Panels; Rear Lid
Lower Trim Panel, Removing and Installing .
Tightening Specifications
2.8
Hinges, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Removing
– Lower the headliner near the hinge mount. Refer to ⇒ Body
Interior; Rep. Gr. 70 ; Roof Trim Panels; Headliner, Removing
and Installing .
– The headliner can now be lowered far enough so that the hex
nut -4- can be removed without damaging the headliner.
– Loosen the hex nuts -4- and bolts -2-, but do not remove them.
Note
♦
Tape off the roof edge and the upper edge of the rear lid, to prevent paint damage.
♦
For the following work procedures, a second technician must hold the rear lid in at the bottom -arrow-.
♦
The gas-filled struts remain installed.
– Remove the hex nut -4- and bolts -2-.
– Remove the hinge -1-.
Installing
Install the hinge -1- in reverse order of removal.
Note
♦
Make sure that the washer -3- is seated correctly.
♦
Recreate the observed sealing procedures.
Tightening Specifications
2.9
Catch, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Removing
– Remove the lock carrier trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Luggage Compartment Trim Panels; Lock Car‐
rier Trim Panel, Removing and Installing .
– Remove the hex nuts -2- and remove the catch -1- from the
lock carrier.
Installing
– Install the catch -1- with the hex nuts -2- on the lock carrier.
– Adjust the catch. Refer to
⇒ “2.10 Catch, Adjusting”, page 67
– Install the lock carrier trim panel. Refer to ⇒ Body Interior; Rep.
Gr. 70 ; Luggage Compartment Trim Panels; Lock Carrier
Trim Panel, Removing and Installing .
Tightening Specifications
2.10
Catch, Adjusting
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст