Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 231
To adjust or check the gap dimensions, use the Gauge - Gap
Adjustment - 3371- . Refer to ⇒ Body Repair; Rep. Gr. 00 ; Body
Gap Dimensions; Rear Body .
– Loosen the catch -5- and adjust at the hinge and the adjusting
buffer after adjustment work. Refer to
– By loosening the left and right bolts -3-, the rear lid -1- can be
adjusted in the oversized holes on the hinge -a arrows- and
-b arrows-.
– After adjusting, perform corrosion protection measures on the
hinge and bolts -3-.
– Adjust the adjusting buffer. Refer to
.
Tightening Specifications
2.4
Adjusting Buffer, Removing and Installing
Removing
– Turn the entire buffer -1- 90° in direction of -arrow a- to remove
the adjusting buffer.
– Remove the buffer from the rear lid -2-.
Installing
– Check the stop -3- for proper seating in the side panel -4-.
– To install, insert the entire buffer -1- at a right angle into the
rear lid -2- in direction of -arrow c-.
– Turn the buffer -1- 90° in direction of -arrow b-.
– Adjust adjusting buffer -1-. Refer to
.
2.5
Adjusting Buffer, Adjusting
Note
If necessary, replace the adjusting buffer. Refer to
.
– Loosen the clamping screw -4- until it is visible in the rubber
buffer.
– Pull the locking retainer -3- out of the adjusting buffer -1-.
– Set the locking retainer to dimension -a- = 12.5 mm.
– Close the rear lid in the initial locking position using light pres‐
sure over the center.
– Open the rear lid again.
– Screw in the clamping screw -1- of the adjusting buffer -2- to
a depth of dimension -a- = 20 mm.
– Check the adjustment.
2.6
Latch, Removing and Installing
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
Removing
Note
If the rear lid does not open, use the emergency release inside the rear lid trim panel to open it manually. Refer
to the Owner's Manual.
– Remove the rear lid lower trim panel. Refer to ⇒ Body Interior;
Rep. Gr. 70 ; Luggage Compartment Trim Panels; Rear Lid
Lower Trim Panel, Removing and Installing .
– Disconnect the connector -3- from the latch -1-.
– Remove the bolts -2- and remove the latch -1- from the rear
lid.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст