Volkswagen Golf / Golf GTI / Golf Variant. Manual — part 548
10 - Evacuating and Charging Valve, Low Pressure Side
Caution
Danger due to refriger‐
ant coming out under
pressure when there is a
defective valve in the re‐
frigerant circuit.
Danger of frost bite to
skin and other parts of
the body.
♦
Only remove when the
refrigerant circuit is emp‐
ty. The connection does
not have a valve. Refer to
⇒ Refrigerant R134a
Servicing; Rep. Gr. 00 ;
A/C System, General In‐
formation .
❑ Removing and installing. Refer to
⇒ “2.9 Evacuating and Charging Valve, Removing and Installing, Low and High Pressure Side”,
11 - Refrigerant Line with Inner Heat Exchanger
❑ From the condenser and Air Conditioning (A/C) compressor
❑ Removing and installing. Refer to
⇒ “2.7 Refrigerant Lines with Inner Heat Exchanger, Removing and Installing”, page 52
.
12 - Air Quality Sensor - G238-
❑ Checking. Refer to Vehicle Diagnostic Tester in the “Guided Fault Finding” function and ⇒ Wiring dia‐
grams, Troubleshooting & Component locations.
❑ Removing and installing. Refer to
⇒ “8.2 Air Quality Sensor G238 , Removing and Installing”, page 151
⇒ “8.3 Function of Air Quality Sensor G238 ”, page 151
.
❑ Only for vehicles with Climatronic.
13 - Fresh Air Intake Cover
❑ Removing and installing. Refer to
⇒ “5.3 Fresh Air Intake Cover, Removing and Installing”, page 115
14 - Fresh Air Intake
❑ Removing and installing. Refer to
⇒ “5.2 Fresh Air Intake, Removing and Installing”, page 115
.
1.2
Component Location Overview - Components Inside Front Passenger
Compartment
1 - Left Vent Temperature Sen‐
sor - G150-
❑ Only for vehicles with
Climatronic.
❑ To check, use the Vehi‐
cle Diagnostic Tester in
the “Guided Fault Find‐
ing” function. Refer to
⇒ Wiring diagrams,
Troubleshooting &
Component locations.
❑ An incorrectly installed
vent temperature sen‐
sor causes flow-gener‐
ated noise
❑ Removing and instal‐
ling. Refer to
.
2 - Driver Side Footwell Vent
❑ Removing and instal‐
ling. Refer to
.
❑ Overview. Refer to
.
3 - Footwell Vent Temperature
Sensor - G192-
❑ Only for vehicles with
Climatronic.
❑ To check, use the Vehicle Diagnostic Tester in the “Guided Fault Finding” function. Refer to ⇒ Wiring
diagrams, Troubleshooting & Component locations.
❑ Removing and installing. Refer to
⇒ “8.8 Footwell Vent Temperature Sensor G192 , Removing and Installing”, page 155
4 - Front Air Distribution Door Motor - V426- or Air Distribution Door Motor - V428-
❑ Removing and installing. Refer to
Removing and Installing”, page 143
❑ Component Location Overview. Refer to
⇒ “7.1 Component Location Overview - Front Actuators”, page 128
5 - Left Temperature Door Motor - V158- or Temperature Regulator Door Motor - V68-
❑ Removing and installing. Refer to
⇒ “7.5 Left Temperature Door Motor V158 with Left Temperature Door Potentiometer/Actuator G220 ,
Removing and Installing”, page 136
❑ Component Location Overview. Refer to
⇒ “7.1 Component Location Overview - Front Actuators”, page 128
6 - Evaporator
❑ Only for vehicles with an Air Conditioning (A/C) system.
❑ Removing and installing. Refer to
⇒ “4.9 Evaporator, Removing and Installing”, page 90
7 - Sunlight Photo Sensor - G107-
❑ Only for vehicles with Climatronic.
❑ Removing and installing. Refer to
⇒ “8.1 Sunlight Photo Sensor G107 , Removing and Installing”, page 150
8 - Evaporator Temperature Sensor - G308-
❑ Only for vehicles with an A/C system.
❑ To check, use the Vehicle Diagnostic Tester in the “Guided Fault Finding” function. Refer to ⇒ Wiring
diagrams, Troubleshooting & Component locations.
❑ Removing and installing. Refer to
⇒ “4.17 Evaporator Temperature Sensor G308 , Removing and Installing”, page 108
.
9 - Defroster Door Motor - V107-
❑ Only for vehicles with Climatronic.
❑ Removing and installing. Refer to
⇒ “7.3 Defroster Door Motor V107 with Defroster Door Motor Position Sensor G135 , Removing and
.
❑ Component Location Overview. Refer to
⇒ “7.1 Component Location Overview - Front Actuators”, page 128
.
10 - Right Temperature Door Motor - V159-
❑ Only for vehicles with Climatronic.
❑ Removing and installing. Refer to
⇒ “7.6 Right Temperature Door Motor V159 with Right Temperature Door Potentiometer/Actuator G221 ,
Removing and Installing”, page 138
.
❑ Component Location Overview. Refer to
⇒ “7.1 Component Location Overview - Front Actuators”, page 128
.
11 - Dust and Pollen Filter
❑ Removing and installing. Refer to
⇒ “4.11 Dust and Pollen Filter, Removing and Installing”, page 92
.
12 - Recirculation Door Motor - V113- or Fresh Air/Recirculating Air/Back Pressure Door Motor - V425-
❑ Recirculation Door Motor - V113- , Removing and installing. Refer to
⇒ “7.4 Recirculation Door Motor V113 , Removing and Installing”, page 134
❑ Fresh Air/Recirculating Air/Back Pressure Door Motor - V425- , Removing and installing. Refer to
Pressure Door Motor Position Sensor G644 , Removing and Installing”, page 140
.
❑ Component Location Overview. Refer to
⇒ “7.1 Component Location Overview - Front Actuators”, page 128
.
13 - Right Vent Temperature Sensor - G151-
❑ Only for vehicles with Climatronic.
❑ To check, use the Vehicle Diagnostic Tester in the “Guided Fault Finding” function. Refer to ⇒ Wiring
diagrams, Troubleshooting & Component locations.
❑ Removing and installing. Refer to
⇒ “8.7 Right Vent Temperature Sensor G151 , Removing and Installing”, page 154
.
❑ An incorrectly installed vent temperature sensor causes flow-generated noise
14 - Fresh Air Blower - V2-
❑ Removing and installing. Refer to
⇒ “4.12 Fresh Air Blower V2 , Removing and Installing”, page 95
.
15 - Front Passenger Side Footwell Vent
❑ Removing and installing. Refer to
⇒ “5.6 Front Passenger Side Footwell Vent, Removing and Installing”, page 117
❑ Overview. Refer to
⇒ “5.1 Overview - Air Routing and Air Distribution in Passenger Compartment”, page 113
16 - Condensation Water Drain Hose
❑ Only for vehicles with an A/C system.
❑ Checking. Refer to
⇒ “4.18 Condensation Water Drain, Checking”, page 109
❑ Removing and installing. Refer to
⇒ “4.19 Condensation Water Drain, Removing and Installing”, page 110
.
17 - Auxiliary Heater Heating Element - Z35- with Auxiliary Air Heater Control Module - J604-
❑ Checking. Refer to
.
❑ Removing and installing. Refer to
18 - Heater Core
❑ Removing and installing. Refer to
⇒ “4.15 Heater Core, Removing and Installing”, page 98
19 - Display and Control Head
❑ Removing and installing. Refer to
⇒ “6.2 Display and Control Head, Removing and Installing”, page 126
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст